In this study we evaluated both NiCr and TaN thin-film resistor material for use with our InP technology. Thermal stability, sensitivity to oxidation, temperature coefficients, and patterning techniques were compared for the two materials. The film stoichiometry was determined using Rutherford backscattering and Auger electron spectroscopy analysis. Electron-beam evaporation of NiCr (80:20) resulted in films that were rich in Cr (30%), due to a higher vapor pressure of Cr. Thus, it was preferentially evaporated from the source. The TaN, on the other hand, was stoichiometric to within a few atomic %. This was due to better composition control with sputter deposition as opposed to electron (e)-beam evaporation from an alloy source. The NiCr showed a 5% increase in Rs when exposed to O2 plasma, and was stable for anneal temperatures of up to 300 °C. Alternatively, the TaN was stable for O2 plasma exposure, but had an increase in Rs of 5% or 10% when annealed at 300 °C in N2 or air ambients, respectively. From a fabrication point of view, the NiCr was more stable during bake cycles. However, it must be encapsulated to protect it from O2 plasma exposure. It can, therefore, be used earlier on in the process. On the other hand, TaN was more stable during plasma exposure, however, it must not be baked at high temperatures. It can thus be used at the back end of the process. The NiCr thickness required to obtain an Rs of 50 Ω/□ was around 250 Å, as opposed to 800 Å for the TaN. This may have an effect on electromigration issues for high current density applications. In addition, the TaN would be better in applications where resistors with higher Rs are required, such as 200 Ω/□.