SEMATECH evaluated the impact of various process options on the overall manufacturing cost of a TSV module, from TSV lithography and etch through post-plate CMP. The purpose of this work was to understand the cost differences of these options in order to identify opportunities to significantly reduce cost. Included in this study were multiple process and materials options for TSV etch, liner, and barrier/seed (B/S). For each of these options, recipes were adjusted for post-etch clean, ECD Cu fill and CMP overburden, and the resulting cost impacts were evaluated. The TSV dimensions used in this study are 5x50 μm and 2x40 μm. These cost comparisons included a sensitivity analysis, highlighting the main factors responsible for the differences. Cost of materials, tool cost, and throughput were the primary factors affecting cost differences, especially in barrier/seed deposition. In some cases the contributions from both these sources were comparable. We explain the assumptions used and some of the uncertainties inherent in this work. For example, where materials costs were significant, we extrapolated the cost of new materials from research quantities to those needed to support high volume manufacturing. We had to estimate throughputs and materials costs using our best engineering judgment, because the recipes have not yet been optimized. We also considered that the tools used on some non-critical steps might be fully depreciated, or a lower cost tool such as is used in wafer level packaging. Despite these uncertainties and assumptions, we were able to extract some fairly clear conclusions. The process options include the following B/S variations: For 5x50 μm TSVs, the B/S film structure is TaN/Ta/Ru/Cu, and the options are with and without the Ru and/or Cu layers. For 2x40 μm TSVs, the B/S structure is TaN/Ru/Cu, with different thicknesses of Ru, and the Cu is an optional seed layer for the field. We also discuss the impact of scaling the TSV dimensions on manufacturing costs. This work is continuing to look at different process options and to apply this methodology to MEOL modules such as temporary bond and debond, wafer thinning, and TSV reveal.