Plastic injection mold made of tool steel is generally utilized for large lots production. Running for small lots of product is a new trend of demand, so that the mold would be relatively expensive and not competitive. The aim of the present work is to find an alternative material and process for low cost injection mold that suitable for small lots. For these reasons, aluminum-glassacrylic particulate composite would be proposed as a material for manufacturing of low cost plastic injection mold. In this work, an insert mold as part of the injection molding was selected for the case study. Composite was examined to know its characteristics. The part with size of (80mm x 10mm x 10mm) and (30mm x30mm x30mm) made of particulate composite material was selected as specimen. Material of the specimen was aluminum powders (<297 μm), glass powders (<74 μm) and acrylic powders (<74 μm); the volume ratio is 1:1:1. Acrylic was used for binder when composite made by layer manufacturing method, using Selective Heater Melting (SHM) machine. The specimen was prepared into three steps: manufacturing of composite (green specimen) by SHM machine, heating green specimen to burn up the acrylic, and resin impregnation. There were 3 types of specimens: green specimen before heating at 700°C, green specimen after heating at 700°C, and green specimen after heating at 700°C that continued by resin impregnation. Tests was performed to investigate its bending strength, surface hardness, surface roughness, and dimensional error. The other composite (specimen) was insert mold, made by layer manufacturing method, using SHM machine. Case study was carried out by testing an insert mold to know the reliability of insert mold. Bending strengths of green specimen, before and after heating at 700°C, were 2.07 and 8.23 MPa, respectively; and after resin impregnation was 17.15 MPa. Dimensional errors in the direction of X, Y, and Z-axis for green specimen of (30mm x 30mm x30mm) before heating at 700°C were 8.65, 2.7, and 3.8 mm, respectively; and after heating at 700°C were 7.90, 1.10 and 0.90 mm, respectively. Surface roughness of green specimen before and after heating at 700°C were 46.12 and 33.48 μm, respectively; and after resin impregnation was 12.17 μm. Surface hardness of specimen after resin impregnation was 14.199 BHN. The amount of plastic parts that could be produced by insert mold was 120 and 126 pieces. Although mechanical strength of this composite was lower than that of tool steel that used for common plastic injection mold, but this composite material was less expensive and suitable for small lots production.