Abstract
Short-run statistical process control (SPC) usually transfers the data of different types of parts through data coding and part-family formation. As plastic injection moulds are mostly made in one-off or very small batches and one mould part can be very different from another, constant machine set-up changes are needed. In this situation, part-family formation becomes very difficult. The part family either becomes too large, introducing variations that are unnecessary or more complex to handle, or there are too many part families to handle. An approach is proposed in the present study with the aim to overcome the aforementioned problems. This approach defines the SPC processes and part families based on data from manufacturing processes in the mould manufacturing workshop. For each mould part to be produced, its manufacturing processes are classified into particular SPC processes, and the part is classified into a specific part family according to prescribed memberships. Through this procedure, unwanted variations are effectively isolated to facilitate and simplify subsequent data processing and interpretation. Domain-specific methods and rules of SPC planning for mould manufacturing are also presented to simplify the application of SPC in this area.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Computer Integrated Manufacturing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.