The need for a high-performance transceiver with high Signal to Noise Ratio (SNR) has driven the communication system to utilize the latest technique identified as oversampling systems. It was the most economical modulator and decimation in the communication system. It has been proven to increase the SNR and is used in many high-performance systems such as in the Analog to Digital Converter (ADC) for wireless transceiver. This research work presented the design of the novel class of decimation and it's VLSI implementation which was the sub-component in the oversampling technique. The design and realization of the main unit of decimation stage that was the Cascaded Integrator Comb (CIC) filter, the associated half-band filters, and the droop correction are also designed. The Verilog HDL code in Xilinx ISE environment has been derived to describe the proposed advanced CIC filter properties. Consequently, Virtex-II FPGA board was used to implement and test the design on the real hardware. The ASIC design implementation was performed accordingly and resulted in power and area measurement on-chip core layout. The proposed design focused on the trade-off between the high speed and the low power consumption as well as the silicon area and high resolution for the chip implementation which satisfies wireless communication systems. The synthesis report illustrates the maximum clock frequency of 332 MHz with the active core area of 0.308 x 0.308 mm2. It can be concluded that VLSI implementation of proposed filter architecture is an enabler in solving problems that affect communication capability in DSP application.