Effect of electrolyte solution on saturated hydraulic conductivity of soils varying in clay type and content, and iron oxides

Abstract

Listen

Translate article

AbstractChanges of hydraulic conductivity (HC) at electrolyte solutions having different combinations of sodium adsorption ratio (SAR)1 and electrolyte concentration (EC), were monitored in soil columns packed with samples from Rhodustalf, Chromustert, Andic Eutropept and Oxic Rhodustult, four subtropical soils varying in clay type and content, and iron oxides. In general, it was observed that the HC dropped with the decrease of EC and with the increase in SAR of solutions, or, with the increase in exchangeable sodium percentage (ESP) of the soil. In montmorillonitic soils the reduction of HC had been most pronounced, while the kaolinite‐rich soils showed only an insignificant drop in HC even at the highest SAR coupled with the lowest EC. The improvement or revival of HC from its final drop was examined upon leaching the soil columns finally with the initial high concentration solution. Montmorillonitic soils showed moderate to high revival of HC, while for montmorillonite‐illite‐kaolinite mixed clayey soils and kaolinitic soils the improvement of HC was low and practically nil respectively. The percentage revival of HC from its final drop was employed as a criterion to assess the major cause of HC reduction and it was found that irrespective of clay mineralogy “dispersion and subsequent pore plugging” played a major role in reducing the HC of soils, though in montmorillonitic soils swelling had been found to be an almost equivalent additional cause of HC drop. Simple correlations (r) between the saturated HC at varying SAR & EC and different physico‐chemical and mineralogical properties have been calculated and its role and implications have been discussed.