The aim of the present study is to prepare a landslide susceptibility map of a region of about 120 km 2, between Gökcesu and Pazarköy (around Mengen, NW Turkey) at approximately 10 km north of the North Anatolian Fault Zone, where frequent landslides occur. For this purpose, mechanisms of the landslides were studied by two-dimensional stability analyses together with field observations, and the parameters controlling the development of such slides were identified. Field observations indicated that the failures generally developed within the unconsolidated and/or semiconsolidated soil units in forms of rotational, successive shallow landslides within the weathered zone in Mengen, Cukurca and Sazlar formations. Although consisting of residual soils, Capak and Gökdag formations do not exhibit landslides as the natural slopes formed on these, do not exceed the critical slope angles. Statistical evaluations and distribution of the landslides on the topographical map showed that such parameters as cohesion, angle of internal friction, slope, relative height, orientation of slopes, proximity to drainage pattern, vegetation cover and proximity to major faults were the common features on the landslides. Digital images were obtained to represent all these parameters on gray scale on the SPOT image and on the digital elevation model (DEM) of the area using image processing techniques. Soil mechanics tests were carried out on 36 representative samples collected from different units, and parameters were determined for two-dimensional stability analyses basing on “sensitivity approach” and for the preparation of digital shear strength map. In order to determine the critical slope angle values for the residual soils, a series of sensitivity analyses were realized by using two-dimensional deterministic slope stability analyses techniques for varying values of cohesion, angle of internal friction and slope height along with varying saturation conditions. According to the results of the sensitivity analyses, the Mengen formation was found to be most susceptible unit to landslides, covering about 33.5% of the region studied in terms of surface area. The distribution of the critical slopes were determined by superimposing the critical slope values from sensitivity analyses on slope map of the study area. On the other hand, iso-cohesion and iso-friction maps were produced by locating the values of cohesion and internal friction angles in a geographic coordinate system such that they coincide with sample locations on the DEM and by further interpolation of the values concerned. The pixel values were evaluated in gray scale from 0 to 255, 0 representing the lowest pixel value and 255 representing the highest. Sensitivity analyses on cohesion and angle of internal friction to investigate the effects of these parameters only on stability, revealed that cohesion was effective at a rate of 70% by itself, while angle of internal friction alone controlled the stability by a rate of 30%. The iso-cohesion and iso-friction maps previously obtained were digitally combined in these rates and a “shear strength map” was prepared. The geographic setting of the study area is such that northern slopes usually receive dense precipitation. In relation to this fact, about 42% of the landslides are due north. Thus, a slope orientation map was prepared using the DEM, and slopes facing north were evaluated as being more susceptible to sliding. Proximity to the drainage pattern was another important factor in the evaluation, as streams could adversely affect the stability by either eroding the toe or saturating the slope, or both. When considered together, in conjunction with the field observations, faults and landslides showed a close association. In the area, about 88% of the landslides were detected within an area closer than 250 m to major faults, therefore, a main discontinuity map was produced using the SPOT image of the region, and “proximity to major faults” was evaluated as a parameter as most of the landslides developed in areas where the vegetation was rather sparse. A vegetation cover map was therefore obtained from the SPOT image, and the areas with denser vegetation were considered to be less susceptible to sliding with respect to the areas with less or no vegetation. Having prepared the maps accounting for the distribution of critical slopes, shear strength properties, relative height, slope angle, orientation of the slopes, vegetation cover, proximity to the drainage pattern, geographic corrections were carried on each of these, and a potential failure map was obtained for the residual soils by superimposing all these maps. Next, a classification was performed on the final map and five relative zones of susceptibility were defined. When compared with this map, all of the landslides identified in the field were found to be located in the most susceptible zone. The performance of the method used in processing the images appears to be quite high, the zones determined on the map being the zones of relative susceptibility.
Read full abstract
Jan 1, 2003
Yoshinori Takeuchi + 3
Open Access
