An accurate estimate of scour depth downstream of culvert outlets is essential for culvert design integrity. Inadequate designs can result in structural failures, leading to increased costs for maintenance and rehabilitation. The present research evaluates the efficacy of numerical models in predicting scour depth and its location downstream of circular culverts under variable flow conditions. Two hydrographs were created for unsteady flow, featuring nine different flow discharges, while steady flow conditions were analysed at flow rates of 14 l/s and 22 l/s. The study investigated circular culverts with inlet blockages of 0%, 15%, and 30%, comparing outcomes with predictions from the Flow-3D software using the renormalisation group (RNG) turbulence model. Extensive experimental data on circular culverts were utilised, with simulations performed using commercial software. This involved analysing the scour's downstream profile, its maximum depth, and its location, and comparing these metrics with actual observed data. The results revealed that the numerical model predictions closely corresponded to the experimental data, even though the simulated scour was generally less than that observed for steady and unsteady flows. The results showed that in unsteady flow conditions and for the discharge of 22 l/s, 30% blockage increased scour by 6.8% and 14.2%, respectively, compared to 15% blockage and non-blocked flow. This increase was 22% and 9.5% for the discharge of 14 l/s, respectively. In the steady case, when the flow rate was adjusted from 14 l/s to 22 l/s, there was a noticeable increase in scour depth downstream of the culvert. While blockage rates impacted the scour patterns significantly in unsteady flow scenarios, escalating blockage percentages did not lead to uniformly proportional increases in scour depth within steady flow environments.
Read full abstract