ABSTRACT The occurrence of the anomalous behaviour of increased isothermal solidification completion time, with increasing temperature in transient liquid phase (TLP) bonding, is investigated for cases of one-dimensional and multi-dimensional migration of solid–liquid boundary, using a numerical model. The analysis shows that the anomalous behaviour is not restricted to the generally reported one-dimensional case but also occurs during multi-dimensional displacements of the solid–liquid interface. It is found that it is possible for isothermal solidification rate constant to increase with increasing temperature and yet increase. Instead of a mere increase in with temperature, it is the extent of the increase that determines if will reduce with an increase in bonding temperature. Increase in with temperature occurs when the increase in is inadequate to overcome the concomitant increase in the volume of liquid produced at a higher bonding temperature. Additionally, the study shows that in contrast to general expectation, an increase in temperature can cause the diffusion-controlled to decrease, notwithstanding a concomitant increase in the solute diffusion coefficient. This unique condition also causes to increase with an increase in bonding temperature. The theoretical findings in this work are corroborated by experimental observations reported in the literature.