BackgroundRobotic suturing training is in increasing demand and can be done using suture-pads or robotic simulation training. Robotic simulation is less cumbersome, whereas a robotic suture-pad approach could be more effective but is more costly. A training curriculum with crossover between both approaches may be a practical solution. However, studies assessing the impact of starting with robotic simulation or suture-pads in robotic suturing training are lacking.MethodsThis was a randomized controlled crossover trial conducted with 20 robotic novices from 3 countries who underwent robotic suturing training using an Intuitive Surgical® X and Xi system with the SimNow (robotic simulation) and suture-pads (dry-lab). Participants were randomized to start with robotic simulation (intervention group, n = 10) or suture-pads (control group, n = 10). After the first and second training, all participants completed a robotic hepaticojejunostomy (HJ) in biotissue. Primary endpoint was the objective structured assessment of technical skill (OSATS) score during HJ, scored by two blinded raters. Secondary endpoints were force measurements and a qualitative analysis. After training, participants were surveyed regarding their preferences.ResultsOverall, 20 robotic novices completed both training sessions and performed 40 robotic HJs. After both trainings, OSATS was scored higher in the robotic simulation-first group (3.3 ± 0.9 vs 2.5 ± 0.8; p = 0.049), whereas the median maximum force (N) (5.0 [3.2–8.0] vs 3.8 [2.3–12.8]; p = 0.739) did not differ significantly between the groups. In the survey, 17/20 (85%) participants recommended to include robotic simulation training, 14/20 (70%) participants preferred to start with robotic simulation, and 20/20 (100%) to include suture-pad training.ConclusionSurgical performance during robotic HJ in robotic novices was significantly better after robotic simulation-first training followed by suture-pad training. A robotic suturing curriculum including both robotic simulation and dry-lab suturing should ideally start with robotic simulation.
Read full abstract