Position Mapping Research Articles

Seed Mapping of Sugar Beet

Individual plant care may well become embodied in precision farming in the future and will lead to new opportunities in agricultural crop management. The objective of this project was to develop and evaluate a data logging system attached to a precision seeder to enable high accuracy seed position mapping of a field of sugar beet. A Real Time Kinematic Global Positioning System (RTK GPS), optical seed detectors and a data logging system were retrofitted on to a precision seeder to map the seeds as they were planted. The average error between the seed map and the actual plant map was about 16–43 mm depending on vehicle speed and seed spacing. The results showed that the overall accuracy of the estimated plant positions was acceptable for the guidance of vehicles and implements as well as potential individual plant treatments.

Performance improvement of small gamma camera using NaI(Tl) plate and position sensitive photo-multiplier tubes

The purpose of this study was to improve the performance of a small gamma camera, utilizing a NaI(Tl) plate and a 5″ position sensitive PMT. We attempted to build a NaI(Tl) plate crystal system which retained all its advantages, while at the same time integrating some of the advantages inherent in an array-type scintillation crystal system. Flood images were obtained with a lead hole mask, and position mapping was performed by detecting hole positions in the flood image. Energy calibration was performed using the energy spectra obtained from each hole position. Flood correction was performed using a uniformity correction table containing the relative efficiency of each image element. The spatial resolution was improved about 16% after correction at the centre field of view. Resolution deterioration at the outer field of view (OFOV) was considerably ameliorated, from 6.7 mm to 3.2 mm after correction. The sensitivity at the OFOV was also increased after correction, from 0.7 cps µCi−1 to 2.0 cps µCi−1. The correction also improved uniformity, from 5.2% to 2.1%, and linearity, from 0.5 mm to 0 mm. The results of this study indicate that the revised correction method can be employed to considerably improve the performance of a small gamma camera using a NaI(Tl) plate-type crystal. This method also provides high spatial resolution and linearity, like array-type crystals do, while retaining the specific advantages of plate-type crystals.

Radiofrequency ablation of cardiac arrhythmias using a three-dimensional real-time position management and mapping system.

A recently developed three-dimensional real-time position management system (RPM) uses an ultrasound ranging technique that enables multiple distance measurements between two reference catheters and a mapping catheter each equipped with ultrasound transducers. In addition to three-dimensional representation of the catheters and ablation sites it displays real-time movements of catheters (including the tip and shaft). A recently released version of the system enables additional geometry reconstruction of the heart chamber and activation mapping. This study included 21 patients (mean age 59 +/- 14.5 years) referred for radiofrequency catheter ablation of various arrhythmias. Geometry was reconstructed by tracing the endocardial contour of the respective heart chambers. Global and local color coded activation maps were constructed to confirm the nature of arrhythmia and to guide ablation. Spontaneous or induced arrhythmias were typical atrial flutter (n = 8), atypical atrial flutter (n = 3), atrioventricular nodal reentrant tachycardia (n = 3), atrial tachycardia (n = 2), atrial fibrillation (n = 2), ventricular tachycardia (n = 2), and Wolff-Parkinson-White syndrome (n = 1). Geometry reconstruction and mapping of arrhythmias were possible in 20 of 21 patients. RPM-guided radiofrequency ablation was successful in 19 (95%) of 20 patients. Due to difficulties in steering the RPM mapping/ablation catheter, in 6 (28%) successfully mapped patients, radiofrequency ablation was performed using another catheter. In one patient, the RPM-guided map was inconclusive and in another patient, ablation failed due to multiple reentrant circuits. No complications were observed. In conclusion, the new RPM system enables geometry reconstruction and three-dimensional positioning of the ablation catheters, reconstruction of the activation maps, marking of anatomic structures and reproducible tracking of multiple ablation sites. The system could be used to guide radiofrequency ablation of atrial and ventricular arrhythmias.

Electron charge density imaging with X-ray holography

A theory of atom resolving X-ray fluorescence holography is presented. It uses the single-scattering approach to derive from Maxwell's equations a solution for imaging electron charge density distribution from the observed X-ray holography data. Experimental holograms from a Fe single crystal are used to demonstrate atom position mapping by the new transform versus Barton's reconstruction algorithm.

Dual-plane stereoscopic particle image velocimetry: system set-up and its application on a lobed jet mixing flow

The technical basis and system set-up of a dual-plane stereoscopic particle image velocimetry (PIV) system, which can obtain the flow velocity (all three components) fields at two spatially separated planes simultaneously, is summarized. The simultaneous measurements were achieved by using two sets of double-pulsed Nd:Yag lasers with additional optics to illuminate the objective fluid flow with two orthogonally linearly polarized laser sheets at two spatially separated planes, as proposed by Kaehler and Kompenhans in 1999. The light scattered by the tracer particles illuminated by laser sheets with orthogonal linear polarization were separated by using polarizing beam-splitter cubes, then recorded by high-resolution CCD cameras. A three-dimensional in-situ calibration procedure was used to determine the relationships between the 2-D image planes and three-dimensional object fields for both position mapping and velocity three-component reconstruction. Unlike conventional two-component PIV systems or single-plane stereoscopic PIV systems, which can only get one-component of vorticity vectors, the present dual-plane stereoscopic PIV system can provide all the three components of the vorticity vectors and various auto-correlation and cross-correlation coefficients of flow variables instantaneously and simultaneously. The present dual-plane stereoscopic PIV system was applied to measure an air jet mixing flow exhausted from a lobed nozzle. Various vortex structures in the lobed jet mixing flow were revealed quantitatively and instantaneously. In order to evaluate the measurement accuracy of the present dual-plane stereoscopic PIV system, the measurement results were compared with the simultaneous measurement results of a laser Doppler velocimetry (LDV) system. It was found that both the instantaneous data and ensemble-averaged values of the stereoscopic PIV measurement results and the LDV measurement results agree well. For the ensemble-averaged values of the out-of-plane velocity component at comparison points, the differences between the stereoscopic PIV and LDV measurement results were found to be less than 2%.

Satellite remote sensing and GIS for the analysis of channel migration changes in the active Yellow River Delta, China

Channel migration in deltaic lowlands tends to be complicated by marine processes and intensified cultural practices. Understanding the ways in which river channels have migrated through time is critical to tackling many geomorphologic and river management problems. Because of large magnitude and rapid rates of change, special surveillance systems are needed to efficiently measure and monitor channel migration. This study presents an application of geographic information technologies for the study of channel migration in the active Yellow River Delta, China. The main source of data was a series of time-sequential Landsat images spanning a period of approximately 19 years. A geographic information system (GIS) was used to support modernized channel position mapping and measurement. The spatio-temporal changes of river banks and channel centerlines were systematically examined, and an attempt was made to relate these computational results with appropriate natural and human processes affecting the delta. This study demonstrates the utility of satellite remote sensing integrated with a GIS in investigating channel migration.

The intestinal epithelial stem cell: the mucosal governor.

All epithelial cells in the small and large intestine are thought to originate from stem cells located towards the base of the crypts of Lieberkühn. To-date, there are no specific intestinal stem cell markers, hence stem cell properties can only be inferred. A range of experimental techniques have been employed including cell position mapping, radiation regeneration (clonogenic) assays, chimeric and transgenic mice. This review discusses the implications of experiments performed using these techniques in order to deduce the number, location and functional properties of stem cells. Stem cell homeostasis is maintained by cell proliferation and death 'through apoptosis'. The various growth and matrix factors and genes which may control these processes, and be important for stem cell function, are discussed along with their carcinogenic and clinical implications.

S-R compatibility: The relative effects of “relevant” spatial and non-spatial variables

RTs were obtained in a task in which a red or a green stimulus could appear at either of two locations - left or right - and subjects responded by pressing a green button on the left or a red button on the right. Two forms of instruction were used, one mapping stimulus colour onto response location, the other mapping stimulus location onto response colour. Faster performance was hypothesized in the former because it entailed fewer operations in response selection. This was confirmed. Faster performance was also hypothesized when the S-R relations in the task for both colour and location could be described by a single recoding rule (both “same” or both “alternative”). This was not confirmed, faster performance being obtained only when colour and location were both “same”. Whilst no specific superiority of performance under a single recoding rule was demonstrated, the faster performance under a colour to position mapping was interpreted as showing the general importance of underlying recoding processes as determinants of RT.

Laser Radar (LIDAR) for Mapping Aerosol Structure

This paper describes a third-generation experimental Q-switched, ruby laser radar or lidar useful for air pollution mapping and meteorological studies. This system differs from its predecessors in that it incorporates (1) automatic inverse-range-squared receiver gain compensation, (2) coaxial transmitter and receiver optics, (3) automatic scanning and pulsing at equal angle increments or time intervals for fixed operation, and at equal distances traveled for mobile operation, and (4) video disk storage and instant replay of scan sequences. Details of these improvements are included. Photographs of typical displays are also included to illustrate atmospheric returns recorded during range-height mapping of a smoke plume from an industrial plant, showing a cross section of the plume's structure; plan position mapping of the effluents from several industrial plants, indicating those emitting particulates; and distance-height mapping, showing differences in pollution and changes in the height of the inversion layer obtained while driving through a city.