ABSTRACT A new laboratory kiln was developed and built to perform over a very wide range of drying conditions. For example, the dry bulb temperature can vary from 30°C to 150°C and the dew point can be adjusted between 20°C and 130°C. Obviously, with such a high level of dew point, pressures over atmospheric pressure may be induced inside the chamber. For this reason, the kiln has been designed to withstand pressure of up to 3 bars. This kiln can also perform vacuum drying. A programmable controller allows the temperature levels to be maintained within ± 0.2°C. Because the whole kiln can be heated only through the agitated water present at the bottom of the kiln, the load temperature can be increased up to 130°C in saturated conditions, without any change of moisture content. The kiln has various sensors attached and is capable of withstanding severe conditions (high temperature, saturated vapour and elevated pressures). At present, air and water temperatures as well as temperature at different locations within the board can be collected during the drying process. A load cell and pressure gauges are also available. The first tests performed using this equipment are presented at the end of the paper.