In order to improve the electromagnetic compatibility performance of electric vehicle bidirectional chargers, the authors propose a main circuit topology and electromagnetic interference of the electric vehicle bidirectional charger. The design adopts the parallel connection of silicon carbide (SiC) MOSFETs and completes the bidirectional charging system based on the cascade connection of dual active bridge (DAB) and three-phase four-wire inverter. This paper mainly analyzes the influence of parasitic inductance on the drive and power loop of the T0-247 packaged switch in actual use, and according to the operating characteristics of the system, different gate resistors are used to reduce switching losses and improve system efficiency. And, we explore on how to reduce the overshoot voltage through the RC absorption circuit, thereby reducing the conducted interference. The result shows the following: the primary side absorption circuit resistance is 470 Ω and the capacitor is 47 nf, the secondary side absorption circuit resistance is 40 Ω and the capacitance is 4.7 nf, and the circuit power is 5000 W. Under the same conditions, without adding the RC absorption circuit, the conducted interference on the AC side does not meet the standard, and the amount of disturbance is large. After adding a suitable RC absorption circuit, the conducted interference on the AC side reaches the required value. Conclusion. This research provides a systematic design scheme and optimization method for designing power electronic devices using SiC.