Abstract

This paper presents the development of a two-stage low noise amplifier (LNA) operating at the S-band frequency that is implemented using the non-simultaneous conjugate match (NSCM) technique. The motivation of this work was to solve the issue of the gain of LNAs designed using the most commonly used technique, i.e. simultaneous conjugate match (SCM), which often produce an increase of other parameter values, i.e. noise figure and voltage standing wave ratio (VSWR). Prior to hardware implementation, the circuit simulation software Advanced Design System (ADS) was applied to design the two-stage S-band LNA and to determine the desired trade-off between its parameters. The proposed two-stage S-band LNA was deployed on an Arlon DiClad527 using a bipolar junction transistor (BJT), type BFP420. Meanwhile, to achieve impedances that match the two-stage S-band LNA circuit, microstrip lines were employed at the input port, the interstage, and the output port. Experimental characterization showed that the realized two-stage S-band LNA produced a gain of 22.77 dB and a noise figure of 3.58 dB at a frequency of 3Â GHz. These results were 6.1 dB lower than the simulated gain and 0.76 dB higher than the simulated noise figure respectively.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.