Thermochromic properties and surface chemical states of reactive magnetron sputtered vanadium oxide thin films at various deposition pressures

Abstract

Listen

Translate article

Vanadium oxide thin films were prepared using reactive magnetron sputtering method, varying the deposition pressures from 4 to 10 mTorr while maintaining the other sputtering parameters constant. Our investigations revealed sensitive dependence of deposition pressure, chemical states of the V and O atoms, crystal phases, and thermochromic (TC) optical modulation. Specifically, the film deposited at 8 mTorr displayed distinct TC characteristics with a prevalent monoclinic m-VO2 phase according to X-ray diffraction (XRD), supported by X-ray photoelectron spectroscopy (XPS). Optical transmittance modulation and electrical property measurements revealed a metal–insulator transition (MIT), confirming the intimate connection between TC characteristics and presence of the m-VO2 phase. Films deposited at pressures lower or higher than 8 mTorr exhibited typical semiconductor behavior without TC characteristics, further supported by in situ XRD, where (110) plane shifted to lower angle upon heating above τC. Chemical state analysis by XPS revealed a clear correlation between V−O peaks and the presence of a VO2 phase, with the film deposited at 8 mTorr displaying relatively large peak fitted area indicative of the VO2 phase. These findings highlight the critical and sensitive dependence of the deposition conditions in tailoring the properties of vanadium oxide thin films and provide valuable insights for potential applications in chromogenic films.