Abstract

Stable wind power generation can ensure the quality of power transmitted by the grid. The application of large-scale grid-connected wind power systems will induce problems such as grid oscillation and frequency instability. In order to solve the problem of abnormal power system interaction caused by large-scale wind power access and improve the stability of grid-connected doubly-fed wind power generation, this paper proposes a stability modeling analysis of grid-connected doubly-fed wind power generation based on small signal model. First, the operating conditions of the grid-connected DFIG are analyzed, and the vector diagrams of the three operating conditions are given. When the grid-connected DFIG is in the super-synchronous working state, the sub-synchronous working state and the synchronous working state. According to the operating conditions of the grid-connected doubly-fed generators, the grid-connected doubly-fed wind power generation system is linearized. According to the relationship between the actual speed and the synchronous speed of the doubly-fed generator, the operating conditions of the doubly-fed generator are analyzed. By introducing the small-signal model, we analyze the small-signal of the grid-connected doubly-fed wind power generation system. The indirect current control circuit is used to perform reactive power compensation for grid-connected doubly-fed wind turbines. By calculating the reactive power loss of the grid-connected DFIG and the reactive power loss of the transmission line, the compensation capacity of the grid-connected DFIG is calculated. The transient voltage of the wind turbine is controlled by the rotor-side frequency converter, combined with the pitch angle control model. So far, this paper has realized the modeling analysis of grid-connected doubly-fed wind power generation stability. The simulation results show that the modeling analysis in this paper is reasonable for the small-signal analysis results of the stability of grid-connected doubly-fed wind power generation. In the rotor voltage simulation test, after the oscillation occurs for 1 s, the model starts to simulate and eliminate the fault. During the simulation period of 0.7 s∼1.0 s, the output voltage of the converter decreased to 168 V, and the voltage waveform did not fluctuate greatly after 1.0 s. The experimental results show that this method can improve the stability of grid-connected doubly-fed wind power generation.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call