Mechanics of plasma exposed spin-on-glass (SOG) and polydimethyl siloxane (PDMS) surfaces and their impact on bond strength

Abstract

Silicone polymer (PDMS), widely used for micro-fluidic and biosensor applications, possesses an extremely dynamic surface after it is subjected to an oxygen plasma treatment process. The surface becomes extremely hydrophilic immediately after oxygen plasma exposure by developing silanol bond (Si OH), which promotes its adhesion to some other surfaces like, silicon, silicon dioxide, glass, etc. Such a surface, if left in ambient dry air, shows a gradual recovery of hydrophobicity. We have found an identical behavior to occur to surfaces coated with a thin continuous film of SOG (methyl silsesquioxane). The chemistry induced by oxygen plasma treatment of a spin-on-glass (SOG) coated surface provides a much higher density of surface silanol groups in comparison to precleaned glass, silicon or silicon dioxide substrates thus providing a higher bond strength with polydimethyl siloxane (PDMS). The bonding protocol developed by using the spin coated and cured SOG intermediate layer provides an universal regime of multi level wafer bonding of PDMS to a variety of substrates. The paper describes a contact angle based estimation of bond strength for SOG and PDMS surfaces exposed to various combinations of plasma parameters. We have found that the highest bond strength condition is achieved if the contact angle on the SOG surface is less than 10°.