Investigation of the mechanical behaviour of magnesium composites

Abstract

Abstract Stress/strain and fracture toughness behaviour of a commercial heat-treatable magnesium alloy reinforced with up to 20 volume% short alumina fibres was studied at room and elevated temperatures. Microscopic examination of the composites, which were prepared by conventional squeeze casting, revealed damage of a small portion of the fibres during the infiltration process. Sufficient chemical reaction between the matrix alloy and alumina reinforcement tends to produce a good bond at the fibre/matrix interface. The tensile-related properties of the composites increased at room and elevated temperatures with increasing content of the reinforcement. The ductility and fracture toughness of the composites decreased at room temperature with increasing reinforcement content. While failure strains of the composites were slightly improved at higher testing temperatures, the fracture toughness decreased significantly as the testing temperature exceeded 100°C. Examination of the fracture surfaces of specimens tested at room temperature showed a mixed mode fracture appearance with predominantly brittle cleavage fracture. The fracture surfaces of specimens tested at temperatures above 100°C revealed increasing fibre/matrix interface debonding and fibre pull-out with increasing testing temperature. Micromechanism examinations of crack initiation and propagation indicated that the fracture process of the composites may be matrix controlled.