Dry wear behavior of A356-SiCp functionally graded composite in unidirectional and reciprocating contacts

Abstract

PurposeThe purpose of this study is to distinguish the difference in tribological behavior of functionally graded composites in two sliding modes, namely, unidirectional and reciprocating.Design/methodology/approachA356-(10 Wt.%)SiCp functionally graded composite material (FGM) was prepared by vertical centrifugal casting and then a comparison was made between the tribological characteristics using pin-on-disk and pin-on-reciprocating plate configurations under identical operating conditions (sliding distance (s): 350 m; load (W): 30 = W = 120 N, in steps of 30 N; and velocity (v): 0.2 = v = 1.2 m/s, in steps of 0.2 m/s). Two types of test pins were considered, namely, a test pin taken from the outer zone of the FGM with maximum particle concentration and a test pin taken from the inner zone of the FGM in a matrix-rich region.FindingsThe study revealed that, for the test pin taken from the outer zone of the FGM in the low-velocity range (0.2–0.4 m/s), the reciprocating wear of the friction pair was dominant, while unidirectional wear was dominant in the velocity range of 0.6–0.8 m/s for the entire load range investigated. However, when the velocity was increased from 1.0 to 1.2 m/s, conflicting nature of dominancy in the wear characteristics of the friction pair was observed, depending on the loading condition. In addition, the inner zone FGM pin underwent seizure in the reciprocating mode, whereas this phenomenon was not seen in the unidirectional mode.Originality/valueDifferences in wear and friction characteristics of FGM friction pairs in two different sliding modes were investigated over a wide range of operating parameters.