Abstract
The traditional flow meter is installed in the pipeline, not only to increase initial investment and cause stress loss to the system, but also to use a large amount of manpower and material resources in the data recording. In some areas that are not easily measured, such as buried in the ground, it can be difficult to measure. In order to solve these problems, based on the LabVIEW2013 as platforms and the hardware of sensor and data acquisition card, combined with the serial communication program to design the flow measurement system, getting traffic through the information collected data and the data acquisition card to convey in the program, get traffic after processing, according to flow to calculate the hydraulic balance, judging by the imbalance rate and the degree of hydraulic balance pipeline system is in a state of hydraulic balance. At last, through the actual test analysis, it is concluded that the flow measurement system for the conclusion of practical application, it not only can be used for pipe flow measurement and equilibrium state judgment, and also to have certain security on accuracy.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
