Design and Analysis of Grass Cutting Machine By Using DFMA Method

Abstract

This paper describes about the implementation of redesign the component of grass cutting machine by using the application of Design for Manufacturing and Assembly (DFMA) methodology. The scope based on the existing grass cutting machine and the appropriate of DFMA methodology. The data was analysed by using Boothroyd-Dewhurst Design for Manufacture and Assembly method to verify the design efficiency, handling ratio and fitting ratio to achieve. The new proposed design of grass cutting machine drawn using CATIA V5 software based As a result, the assembly time for redesign showed an improvement of 18.68% where the assembly time was reduced from 568.84 s to 462.59 s and design efficiency was increased 8.33% from 24.40% to 34.70%. The total part, handling ratio fitting ratio and cost of existing design is reduced. Eventually, the improvement of redesign grass cutting machine the best design with optimal value is accomplished.