Statement of problemA consensus on whether or how to treat eroded dentin to bond to composite resins is lacking. The role of gels containing chlorhexidine (CHX), epigallocatechin-3-gallate (EGCG), and proanthocyanidin (PAC) in controlling erosive wear progression needs to be evaluated for bonding. PurposeThe purpose of this in vitro study was to evaluate the effect of gels containing antiproteolytic agents (CHX or EGCG) or an antiproteolytic and also collagen crosslinking agent (PAC) to control tooth wear progression on the microtensile bond strength (μTBS) of an adhesive system plus a composite resin to simulated eroded dentin. Material and methodsSuperficial occlusal dentin surfaces obtained from sectioned third molars were ground with SiC paper (600-grit; 1 minute; N-normal dentin) or subsequently submitted to an initial erosive challenge (Coca-Cola; 5 minutes). They then received one of the following treatments: application of a placebo (P), a 0.12% CHX digluconate, an EGCG at 400 μM, or a 10% PAC gel (vehicle: hydroxyethylcellulose, propylene glycol, methylparaben, imidazolidinyl urea, and deionized water; active principle: as per the experimental groups when applicable) or no treatment (C: control). Initially demineralized dentin was also submitted to pH cycling (Coca-Cola; 5 minutes, 3×/day, 5 days) to simulate eroded dentin (E). After acid etching all the specimens, adhesive Adper Single Bond 2 was applied, and composite resin (Filtek Z350 XT) was placed. After 24 hours storage in distilled water at 37 °C, the specimens were sectioned into beams, and the μTBS was tested at 0.5 mm/minute. The μTBS values obtained were evaluated considering each tooth as an experimental unit, and 2-way ANOVA and the Tukey post hoc test for multiple comparisons were applied (α=.05). ResultsImmediate μTBS values for the eroded dentin were always lower than those for the normal dentin, irrespective of whether any of the gels were applied for wear control. ConclusionsCHX, EGCG, PAC, and placebo gels, applied after the initial demineralization and before the pH cycling to simulate the eroded dentin, had a similar effect on the μTBS of the adhesive system plus the composite resin to simulated eroded dentin when compared with nonapplication (control).