Deformation and fracture of thin films on compliant substrates are key factors constraining the performance of emerging flexible substrate devices. [1-3] These systems often contain layers of thin polymer, ceramic and metallic films and stretchable interconnects where differing properties induce high normal and shear stresses. [4] As long as the films remain bonded to the substrates, they may deform far beyond their freestanding form. Once debonded, substrate constraint disappears leading to film failure. [3] Experimentally it is very difficult to measure properties in these systems at sub-micron and nanoscales. Theoretically it is very difficult to determine the contributions from the films, interfaces, and substrates. As a result our understanding of deformation and fracture behavior in compliant substrate systems is limited. This motivated a study of buckle driven delamination of thin hard tungsten films on pure PMMA substrates. The films were sputter deposited to thicknesses of 100 nm, 200 nm, and 400 nm with a residual compressive stress of 1.7 GPa. An aluminum oxide interlayer was added on several samples to alter interfacial composition. Buckles formed spontaneously on the PMMA substrates following film deposition. On films without the aluminum oxide interlayer, an extensive network of small telephone cord buckles formed following deposition, interspersed with regions of larger telephone cord buckles. (Figure 1) On films with an aluminum oxide interlayer, telephone cord buckles formed creating a uniform widely spaced pattern. Through-substrate optical observations revealed matching buckle patterns along the film-substrate interface indicating that delamination occurred for large and small buckles with and without an interlayer. The coexistence of large and small buckles on the same substrate led to two distinct behaviors as shown in Figure 2 where normalized buckle heights are plotted against normalized film stress. The behaviors deviate significantly from behavior predicted by rigid elastic solutions. To address this issue we developed a finite element analysis technique that employed a cohesive zone model to simulate interfacial crack growth. Specifying the traction-separation relationship, cohesive strength, and work of separation along with film thickness, film stress, and film and substrate properties, buckle width and height were determined as a function of interfacial toughness. The simulations indicate that an analysis based on rigid substrate solutions significantly underestimate toughness for prescribed buckle widths: a result consistent with an analysis by Yu and Hutchinson [5] that pieced together a solution based on non-linear plate theory with a solution for the linear film on substrate problem. More importantly, the results defined a lower limiting bound to seemingly disparate buckle deflection data (Figure 2). The variance from linear elastic behavior, especially for the small buckles, indicates more than substrate compliance is controlling behavior. Comparison of the experimental results with cohesive zone simulations suggests that the two buckle behaviors are associated with different levels of substrate yielding. In this presentation we will use the results to show how substrate compliance and deformation affect delamination and buckling of films on compliant substrates and provide a means to predict device performance.
Read full abstract
Jan 12, 2010
H.L Sun + 4
Open Access