In this study, we investigated the formation and evolution of the corrosion layers in alkali-activated mortar and ordinary Portland cement mortar exposed to sulfuric acid and acetic acid environments with different pH values, and explored the differences in the deterioration mechanisms. The experimental results indicated that ordinary Portland cement (OPC) mortars experienced more severe deterioration in terms of appearance, mass loss, and strength loss as compared with alkali-activated mortars exposed to an acetic acid environment, but their neutralization depths were smaller. Alkali-activated fly ash (AAF) mortar had a the relatively intact appearance but the greatest neutralization depth, which was due to its stable three-dimensional network but highly porous structure. To sum up, alkali-activated fly ash/slag (AFS) mortar had the best resistance to acid attack. In addition, the mortars exposed to acetic acid suffered greater deterioration than those exposed to sulfuric acid with the same pH values, which was mainly due to the highly porous corrosion layer formed in acetic acid, whereas crystallization of gypsum in sulfuric acid had a pore filling effect. However, for alkali-activated slag (AAS) and OPC mortars exposed to a sulfuric acid environment, extensive gypsum resulted in the formation of micro-cracks, and the corrosion layer of OPC mortar was more prone to fall off. OPC mortar also had the greatest resistance difference values of the continuously connected micro-pores before and after acid corrosion, followed by AAS, AAF, and AFS mortars, and these values for all the specimens were smaller in sulfuric acid. Furthermore, the gaps between acetic and sulfuric acid attacks increased with increased calcium content in binders, which were 7%, 13%, 21%, and 29% for AAF, AFS, AAS, and OPC mortars, respectively. Thus, it can be inferred that an appropriate amount of gypsum existed in the corrosion layer which could act as a barrier to some extent ina sulfuric acid environment.
Read full abstract