Speciation Of Selenium Compounds Research Articles

Final report for CCQM-K107: total elements and selenomethionine in human serum

Routine tests that measure the concentration of electrolytes in serum are needed for diagnosis and management of renal, endocrine, acid-base, water balance and other conditions such as screening D- and A-vitamin disorders, kidney insufficiency, bone diseases and leukaemia. The diagnostic concentration ranges for many such markers are narrow, requiring reference methods with small uncertainty. Serum concentration of total selenium (Se) is important in health studies but there is increasing interest in the speciation of selenium compounds in clinical samples such as serum and individual Se- Species are bio-indicators of Se status.The last CCQM IAWG key comparison for elements in the clinical area (CCQM-K14: Ca in human serum) was organized in 2003 and the previous key comparison (CCQM-K60) for Se and Se species used a wheat flour sample. Therefore, the CCQM IAWG agreed that CCQM-K107 and a parallel pilot study CCQM-P146 should be carried out. The candidate human serum sample used for both CCQM-K107 and P146 is of high complexity and contains approximately 1000-fold lower concentrations of selenium methionine (SeMet) than those encountered in the CCQM-K60 wheat flour. This significantly broadens the scope and degree of difficulty of earlier measurements in this field.A total of eleven institutes participated in CCQM-K107 (11 participants for total elements and 7 for SeMet). The performance of the majority of the K107 participants for all the measurands was very good, illustrating their ability to obtain accurate results for analytes such as electrolytes at mg kg-1 level, essential elements at µg kg-1 level and selenium species at µg kg-1 level in a complex biological fluid. The range of agreement between participants was within the interval of ± 0.1% for Ca and up to ± 1.8% for Fe.CMC claims based on total elements in this study may include other elements with similar core competencies (e.g. Se, Cu, Zn) in a wide range of biological materials (including liquids and solids) at a similar level of performance using the same measurement technique applied in CCQM-K107 provided that there are no additional factors (e.g. blank or dissolution issues). CMC claims based on SeMet measurements in this study may be applied to other biological matrices (e.g., tissues) provided that the concentration range is similar and due diligence is taken to ensure an appropriate extraction process is achieved and species specific spikes are available for quantitation by isotope dilution. Indeed, having accepted such conditions, application to quantitation of other organometallic species and other elements in similar matrices should be possible with the same level of performance.Main textTo reach the main text of this paper, click on Final Report. Note that this text is that which appears in Appendix B of the BIPM key comparison database kcdb.bipm.org/.The final report has been peer-reviewed and approved for publication by the CCQM, according to the provisions of the CIPM Mutual Recognition Arrangement (CIPM MRA).

Speciation of selenium compounds by open tubular capillary electrochromatography‐inductively coupled plasma mass spectrometry

We introduce a T-type interface and a crossflow nebulizer to find ways to combine CEC with inductively coupled plasma MS (ICP-MS) detection for selenium speciation. For CEC separation, we employed a macrocyclic polyamine-bonded phase capillary as the separation column and a bare fused-silica capillary filled with the make-up liquid (0.05 M HNO3). The effect of nebulizer gas flow rate, make-up liquid flow, type, concentration and pH of the mobile phase on the separation have been studied. Tris buffer of 50 mM at pH 8.50 gave the best performance for selenium speciation. The reproducibility of the retention time indicated that sample injection by electrokinetic and nebulizer gas flow was better than that by self-aspiration alone. The detection limits for selenate, selenite, selenocystine and selenomethionine were found to be 2.40, 3.53, 12.86 and 11.25 ng/mL, respectively. Due to the high sensitivity and element-specific detection, as well as the high selectivity of the bonded phase, quantitative analysis of selenium speciation in urine was also achieved.

Quantification and Speciation of Mercury and Selenium in Fish Samples of High Consumption in Spain and Portugal

Mercury (Hg) and selenium (Se) determinations were carried out to evaluate human exposure to those elements through fish consumption in Spain and Portugal. Atomic fluorescence spectroscopy (AFS) was applied in a cold vapor mode for total mercury quantification and was also hyphenated to gas chromatography (GC) to achieve the speciation of organomercurial species in fish samples. The results obtained show the highest concentration of Hg in swordfish and tuna (0.47+/-0.02 and 0.31+/-0.01 microg g-1, respectively), and a much lower concentration in sardine, mackerel shad, and octopus (0.048+/-0.002, 0.033+/-0.001, and 0.024+/-0.001 microg g-1, respectively). The determination of alkyl mercury compounds revealed that 93-98% of mercury in the fish samples was in the organic form. Methylmercury (MeHg) was the only species found in the three fish species with higher mercury content. Total selenium concentration was high in sardine, swordfish, and tuna (0.43+/-0.02, 0.47+/-0.02, and 0.92+/-0.01 microg g-1, respectively), but low in mackerel shad and octopus (0.26+/-0.01 and 0.13+/-0.01 microg g-1, respectively). Speciation of selenium compounds was done by high-performance liquid chromatography in conjunction with inductively coupled plasma mass spectrometry (LC-ICP-MS). Selenomethionine (SeMet) was the only selenium compound identified in the fish samples with higher selenium content. Among the fish species studied, sardine had the most favourable Se:Hg and SeMet:MeHg molar ratios; therefore, its consumption seems to be preferable.

Selenium and mercury bioaccessibility in fish samples: an in vitro digestion method

The assessment of hazard from selenium (Se) and mercury (Hg) contaminants in the food chain based on their potential bioaccessibility and on estimate of their actual content in fish is reported under an in vitro model. Atomic fluorescence spectroscopy (AFS) was applied for total selenium and mercury quantification. Selenium and mercury bioaccessibility varied depending on the type of fish analyzed. Se solubility in the gastrointestinal supernatants was higher in swordfish and sardine (76 and 83%, respectively) than in tuna (50%). A low Hg bioaccessibility (9–17%) was found for all the samples. Simulated human gastric and intestinal digestion led to the identification of selenomethionine (SeMet) and organic mercury in the three digested fish. Furthermore, these species were not modified during the digestion. Speciation of selenium compounds was done by liquid chromatography in conjunction with inductively coupled plasma mass spectrometry (LC–ICP-MS). Sardine had the most favorable Se:Hg, [Se:Hg] bioaccessible and [SeMet:Hg] bioaccessible molar ratios, making it preferable to tuna and swordfish. The effect of cooking was also evaluated.

Separation of soluble selenium compounds in muscle from seven animal species using size exclusion chromatography and inductively coupled plasma mass spectrometry

To study the role of selenium compounds for the quality and nutritional value of meat, speciation of selenium compounds was performed in two muscles from each of seven animal species (chicken, turkey, duck, ostrich, lamb, cattle and pig). Soluble selenium compounds were separated by size-exclusion chromatography (SEC) and detected by inductively coupled plasma-mass spectrometry (ICP-MS). Four selenium peaks were found in the muscle extracts by SEC, with partition coefficients (Kav) of 0.02, 0.44, 0.74 and 0.86, respectively. The second and third peaks had a chromatographic mobility approximately corresponding to that of tetrameric glutathione peroxidase and selenoprotein W, respectively, and they contained 68–100% of the recovered selenium in different muscles. The distribution of selenium among the four peaks varied considerably in muscles from different species, the second peak accounting for 28–71% of the recovered selenium and the third peak for 17–72%. These differences in selenium distribution among animal species are discussed in relation to meat quality and nutritional value.

Speciation of selenium compounds from high selenium broccoli is affected by the extracting solution.

The speciation of selenium compounds from high selenium broccoli (876 microg/g) depends on the extraction conditions. Twenty-seven extraction conditions were explored involving nine different buffering systems between pH 1 and pH 9. In nonbuffered extractions of broccoli, more than 40% of the spiked Se-methylselenocysteine was not recovered in the filtered solution. However, in buffered extractions, losses for Se-methylselenocysteine ranged from 10 to 20%. Mass balance indicated that approximately 30% of naturally occurring selenium in broccoli samples was volatilized and lost to the atmosphere when buffered extractions were made. Solid phase extractions indicated that the polarity of selenium compounds in solution was also dependent on the extracting solution. High-pressure liquid chromatography coupled to an inductively coupled plasma mass spectrometer was used to show that selenium compounds extracted from broccoli reacted with the extracting solution. Compound identities were assigned by matching retention times to standards of selenite, selenate, methylseleninic acid, Se-methylselenocysteine, selenomethionine, and the selenonic acids of Se-methylselenocysteine and selenomethionine. Changes in speciation were analyte-, pH-, and buffer-dependent, but generally, a higher pH resulted in more highly oxidized selenium compounds. For valid conclusions to be drawn from the analytical data, the extraction conditions should match the conditions present in the matrix or be specified for a particular application such as a simulated gastrointestinal digestion.

Speciation of selenium compounds with ion-pair reversed-phase liquid chromatography using inductively coupled plasma mass spectrometry as element-specific detection

For selenium speciation analysis, the hyphenation of chromatographic separation with element-specific detection has proved a useful technique. A powerful separation system, which is capable of resolving several biologically and environmentally important selenium compounds in a single column, is greatly needed. However, that has been difficult to achieve. In this paper eight selenium compounds, namely, selenite [Se(IV)], selenate [Se(VI)], selenocystine (SeCys), selenourea (SeUr), selenomethionine (SeMet), selenoethionine (SeEt), selenocystamine (SeCM) and trimethylselenonium ion (TMSe +), were separated by using mixed ion-pair reagents containing 2.5 m M sodium 1-butanesulfonate and 8 m M tetramethylammonium hydroxide as a mobile phase. The separation of these anionic, cationic and neutral organic selenium compounds on a LiChrosorb RP18 reversed-phase column took only 18 min at a flow-rate of 1.0 ml/min with isocratic elution, and baseline separation among the six organic Se compounds was achieved. Inductively coupled plasma mass spectrometry (ICP-MS) was employed as element-specific detection. A comparison of ICP-MS signal intensity obtained with a Barbington-type nebulizer and with an ultrasonic nebulizer (USN) was made. Different signal enhancement factors were observed for the various selenium compounds when a USN was used. The speciation technique was successfully applied to the study on chemical forms of selenium in a selenium nutritional supplement. Selenomethionine was found to be the predominant constituent of selenium in the supplement.

Speciation of Selenium Compounds

The toxicity and essential nature of selenium in the environment depend on its concentration and on the chemical forms in which it is present. Dissolved inorganic selenium can be found in natural waters as selenides (Se-II), colloidal elemental selenium (Se0), selenite (SeIV) as well as selenate (SeVI). Organic forms of selenium that may be found in organisms, air or in the aqueous environment are volatile methylselenides, trimethylselenonium ion and selenoamino acids. This review article intends to show some general ideas in speciation analysis of selenium and to highlight some important procedures.