Abstract Scrap vulcanized rubber has been used principally for the manufacture of reclaimed rubber, which exhibits properties inherent in the original polymers of the scrap. Little has been found in the literature on the utilization of scrap vulcanized rubber as a low-cost starting material for controlled polymer synthesis. In the present investigation scraps containing natural and Type S synthetic rubbers have been modified to produce chemically different polymers possessing properties not usually associated with the initial elastomers. The authors believe that reactions with vulcanized rubber are not usually the same as reactions with the raw polymers and in this work the physical means of accomplishing the reaction are different. In 1938 Bacon and Farmer reported that when masticated raw natural rubber and maleic anhydride were dissolved in a solvent and the solution was heated in the presence of benzoyl peroxide, the ingredients reacted, yielding a variety of tough, fibrous, or resinous products. When vulcanized natural and Type S synthetic rubber scraps were reclaimed in a Reclaimator (a specially designed extruder type plasticator, made by the U. S. Rubber Reclaiming Co., Inc.) in the presence of a critical concentration of certain activated unsaturated compounds, a reaction occurred between the unsaturated compound and the scrap vulcanized rubber. With maleic anhydride, the resulting product was a carboxylated and replasticized rubber. This elastomer exhibited vulcanizing versatility via the carboxyl groups—i.e., curing with bivalent metallic oxides, diamines, glycols, epoxy resins, and diisocyanates. The polarity imparted by the carboxyl groups and the degree of crosslinking of the polymer appear responsible for its oil resistance, a property not normally present in a tire reclaim. The blocking of the double bonds, either by reaction at the double bond or by steric hindrance, added to the good aging properties anticipated with nonsulfur vulcanizates.