A major enhancement in temperature stabilization of a filament has recently been achieved by means of the Halas–Kamiński bridge, in which the reference resistance of one leg is directly proportional to the filament temperature. In this article we describe a novel version of this type of electronic circuit which feeds dc power voltage to the filament via a switching transistor. The switching frequency is regulated by means of a triangular waveform generator incorporated into the system. The duration of the heating peak (square wave) is automatically adjusted properly once at each break between two subsequently appearing heating peaks, which is the interval when the bridge imbalance signal is measured. At the end of each break the bridge imbalance signal is kept on the output of the sample-and-hold amplifier. This signal compared with the generator output voltage provides the square wave for the switching transistor. The application of this circuit for a thermal ionization mass spectrometry is simple and straightforward. The filament temperature is set by two decade low-ohm resistors. Long-term variance of the ion current is approximately 5 times lower than that obtained by use of a commercial voltage stabilizer for the filament supply. It is shown theoretically that stabilization of the filament resistance results in the lowest possible variance of temperature.