Quantum Illumination Protocol Research Articles

Detection scheme using a beam splitter and on-off detectors for non-Gaussian state-based quantum illumination with attenuation

Quantum illumination is an entanglement-based protocol for target detection. The use of a two-mode squeezed vacuum (TMSV) state as a type of Gaussian state has been widely discussed. In our previous study, we found that the quasi-Bell state, which is a non-Gaussian state, outperforms the TMSV state in the quantum illumination protocol with attenuation. In this paper, we construct a detection scheme using practical elements and demonstrate that it can outperform the TMSV state without using the photon-number resolution.

Time alignment quantum illumination based on single real-time coincidence counting

We propose and demonstrate an improved quantum illumination protocol based on the time correlation of twin photons, for the high signal-to-noise ratio (SNR) of target detection and signal reconstruction in the strong noise environment. The Hong-Ou-Mandel (HOM) interferometer is applied after the spontaneous parametric down-conversion (SPDC) process to construct a probing twin-beam in which the photon times are precisely aligned between the beams. At the radar receiver, we put forward a single real-time coincidence counting (SRCC) method on a series of time slices to reconstruct the probe signals of pulse radar and calculate the SNR advantages against the conventional pulse radar, as well as the quantum illumination (QI) protocol. Our main achievements in this research are the realization of real-time detection of quantum information while acquiring a higher SNR than QI and classical illumination (CI) protocols, as well as its demonstration of strong robustness to noise and losses, which also proposes what we believe to be a novel way for quantum target detection.

Evaluation on quantum illumination radar with quantum limited amplification.

Based on Quantum illumination (QI) protocol, researcshers have developed prototypes of quantum radar and demonstrated its quantum enhancement. Nevertheless, there are still difficulties in the practical application for QI radar, especially the trade-off between the detection range and quantum enhancement, as well as the construction of the optimized receiver. Some studies have suggested that the potential solutions to these difficulties are to deploy the quantum limited amplifiers in QI radars, and have envisioned different amplification schemes. In this paper, we establish a universal and effective method to evaluate the signal-to-noise ratio of QI radar. It connects QI radar theory with classical radar signal processing theory, providing support for researchers to evaluate the performance of various QI radar schemes from a radar perspective. Based on this method, we prove that any quantum limited phase-insensitive amplification scheme will seriously weaken the quantum enhancement of QI radar. Furthermore, we also demonstrate that the QI radar with phase-sensitive amplified idler has no advantage over the optimal classical illumination. These results can help us avoid some unreasonable QI radar schemes. In addition, we believe that the proposed method can also be applied to explore other potential QI radar schemes and contribute to promoting the application development of QI radar.

Evaluating the detection range of microwave quantum illumination radar

AbstractBased on quantum illumination (QI) protocol, microwave quantum radar has been developed, which has attracted great interest from radar researchers. While, according to the QI protocol, the quantum advantage of QI radar is related to the power of generated signal, which may lead to a trade‐off between its quantum advantage and the maximum detection range. However, the maximum detection range is an important indicator to measure the performance of the radar. Therefore, it is necessary to quantitatively analyse the maximum detection range and quantum advantages of microwave QI radar, which will help us understand its performance from the perspective of radar applications and further evaluate the potential application scenarios and future research directions of it. The microwave quantum radar equation is developed, by the authors, based on the classical radar equation with the consideration of the quantum properties of extremely weak signals. Then, the maximum detection range of QI radar and classical two mode noise radar in different microwave bands is comprehensively compared and analysed. The possible applications of microwave QI radars in different bands are also discussed. In addition, the authors demonstrate that the symmetrical quantum limited amplification actually has no contribution to improving the detection range of a QI radar.

Noise rejection through an improved quantum illumination protocol

Quantum illumination protocols can be implemented to improve imaging performance in the low photon flux regime even in the presence of both background light and sensor noise. However, the extent to which this noise can be rejected is limited by the rate of accidental correlations resulting from the detection of photon or noise events that are not quantum-correlated. Here we present an improved protocol that rejects up to gtrsim 99.9% of background light and sensor noise in the low photon flux regime, improving upon our previous results by an order of magnitude. This improvement, which requires no information regarding the scene or noise statistics, will enable extremely low light quantum imaging techniques to be applied in environments previously thought difficult and be an important addition to the development of covert imaging, quantum microscopes, and quantum LIDAR.

Dynamic Target Detection and Tracking Based on Quantum Illumination LIDAR

In the detection process of classic radars such as radar/lidar, the detection performance will be weakened due to the presence of background noise and loss. The quantum illumination protocol can use the spatial correlation between photon pairs to improve image quality and enhance radar detection performance, even in the presence of loss and noise. Based on this quantum illumination LIDAR, a theoretic scheme is developed for the detection and tracking of moving targets, and the trajectory of the object is analyzed. Illuminated by the quantum light source as Spontaneous Parametric Down-Conversion (SPDC), an opaque target can be identified from the background in the presence of strong noise. The static objects obtained by classical and quantum illumination are compared, respectively, and the advantages of quantum illumination are verified. The moving objects are taken at appropriate intervals to obtain the images of the moving objects, then the images are visualized as dynamic images, and the three-frame difference method is used to obtain the target contour. Finally, the image is performed by a series of processing on to obtain the trajectory of the target object. Several different motion situations are analyzed separately, and compared with the set object motion trajectory, which proves the effectiveness of the scheme. This scheme has potential practical application value.

Progress Toward an All-Microwave Quantum Illumination Radar

Quantum illumination has been suggested as a way to improve the sensitivity of remote target detection by taking advantage of quantum entanglement between a traveling electromagnetic beam of light interrogating the target, and a second beam kept in the lab. In the microwave domain, superconducting quantum circuit utilizing superconducting Josephson tunnel junctions can be used as quantum-limited amplifiers of faint microwave signals, as well as bright sources of quantum entangled signals. These Josephson parametric amplifiers (JPAs) are poised to become fundamental building block in a future quantum illumination radar operating in the microwave domain. Demonstrating a practical advantage of quantum illumination with ambient temperature signals is, however, challenging. Indeed, current quantum protocols are not practical as they require a complex receiver with stringent phase-matching conditions, which cannot be met in the field. Notably, it is also not currently known how one can transfer faint microwave signals out of cryogenic systems without destroying their fragile entanglement. In this article, we discuss the recent progress and challenges regarding the development of an all-microwave quantum illumination radar using the recently developed and implemented quantum-enhanced noise radar protocol. This quantum illumination protocol is simpler to implement and procures a quantum enhancement over its classical analog. Finally, we discuss different strategies that may resolve the issue of transmitting microwave entanglement under ambient conditions. We, thus, conclude that successful transmission of entangled microwaves can be done in the near future, with possible demonstrations of practical quantum advantage over short distances.

Joint measurement of time\u2013frequency entanglement via sum frequency generation

We propose, analyze, and evaluate a technique for the joint measurement of time–frequency entanglement between two photons. In particular, we show that the frequency sum and time difference of two photons could be simultaneously measured through the sum-frequency generation process, without measuring the time or frequency of each individual photon. We demonstrate the usefulness of this technique by using it to design a time–frequency entanglement based continuous variable superdense coding and a quantum illumination protocol. Performance analysis of these two protocols suggests that the joint measurement of strong time–frequency entanglement of non-classical photon pairs can significantly enhance the performance of joint-measurement based quantum communication and metrology protocols.

Noisy Receivers for Quantum Illumination

Quantum illumination (QI) promises unprecedented performances in target detection but there are various problems surrounding its implementation. Where target ranging is a concern, signal and idler recombination forms a crucial barrier to the protocol's success. This could potentially be mitigated if performing a measurement on the idler mode could still yield a quantum advantage. In this paper we investigate the QI protocol for a generically correlated Gaussian source and study the phase-conjugating (PC) receiver, deriving the associated SNR in terms of the signal and idler energies, and their cross-correlations, which may be readily adapted to incorporate added noise due to Gaussian measurements. We confirm that a heterodyne measurement performed on the idler mode leads to a performance which asymptotically approaches that of a coherent state with homodyne detection. However, if the signal mode is affected by heterodyne but the idler mode is maintained clean, the performance asymptotically approaches that of the PC receiver without any added noise.

Quantum illumination reveals phase-shift inducing cloaking

In quantum illumination entangled light is employed to enhance the detection accuracy of an object when compared with the best classical protocol. On the other hand, cloaking is a stealth technology based on covering a target with a material deflecting the light around the object to avoid its detection. Here, we propose a quantum illumination protocol especially adapted to quantum microwave technology. This protocol seizes the phase-shift induced by some cloaking techniques, such as scattering reduction, allowing for a 3 dB improvement in the detection of a cloaked target. The method can also be employed for the detection of a phase-shift in bright environments in different frequency regimes. Finally, we study the minimal efficiency required by the photocounter for which the quantum illumination protocol still shows a gain with respect to the classical protocol.

Quantum Estimation Methods for Quantum Illumination.

Quantum illumination consists in shining quantum light on a target region immersed in a bright thermal bath with the aim of detecting the presence of a possible low-reflective object. If the signal is entangled with the receiver, then a suitable choice of the measurement offers a gain with respect to the optimal classical protocol employing coherent states. Here, we tackle this detection problem by using quantum estimation techniques to measure the reflectivity parameter of the object, showing an enhancement in the signal-to-noise ratio up to 3dB with respect to the classical case when implementing only local measurements. Our approach employs the quantum Fisher information to provide an upper bound for the error probability, supplies the concrete estimator saturating the bound, and extends the quantum illumination protocol to non-Gaussian states. As an example, we show how Schrödinger's cat states may be used for quantum illumination.

Quantifying the source of enhancement in experimental continuous variable quantum illumination

A quantum illumination protocol exploits correlated light beams to enhance the probability of detection of a partially reflecting object lying in a very noisy background. Recently a simple photon-number-detection based implementation of a quantum illumination-like scheme has been provided in [Lopaeva {\it et al,}, Phys. Rev. Lett. {\bf 101}, 153603 (2013)] where the enhancement is preserved despite the loss of non-classicality. In the present paper we investigate the source for quantum advantage in that realization. We introduce an effective two-mode description of the light sources and analyze the mutual information as quantifier of total correlations in the effective two-mode picture. In the relevant regime of a highly thermalized background, we find that the improvement in the signal-to-noise ratio achieved by the entangled sources over the unentangled thermal ones amounts exactly to the ratio of the effective mutual informations of the corresponding sources. More precisely, both quantities tend to a common limit specified by the squared ratio of the respective cross-correlations. A thorough analysis of the experimental data confirms this theoretical result.

A detailed description of the experimental realization of a quantum illumination protocol

In this paper we propose and realise a practical quantum enhanced sensing protocol aimed at the detection of a partially reflecting object in a lossy and noisy environment. Our scheme is inspired by the theoretical quantum illumination protocol elaborated by Lloyd (2008 Science 321, 1463) and Tan et al (2008 Phys. Rev. Lett. 101, 253601). We demonstrate that when only photon counting is allowed our quantum protocol performs astonishingly better than the best classical counterpart.

Secure communication via quantum illumination

In the quantum illumination protocol for secure communication, Alice prepares entangled signal and idler beams via spontaneous parametric downconversion. She sends the signal beam to Bob, while retaining the idler. Bob imposes message modulation on the beam he receives from Alice, amplifies it, and sends it back to her. Alice then decodes Bob’s information by making a joint quantum measurement on the light she has retained and the light she has received from him. The basic performance analysis for this protocol—which demonstrates its immunity to passive eavesdropping, in which Eve can only listen to Alice and Bob’s transmissions—is reviewed, along with the results of its first proof-of-principle experiment. Further analysis is then presented, showing that secure data rates in excess of 1 Gbps may be possible over 20-km-long fiber links with technology that is available or under development. Finally, an initial scheme for thwarting active eavesdropping, in which Eve injects her own light into Bob’s terminal, is proposed and analyzed.

Experimental realization of quantum illumination.

We present the first experimental realization of the quantum illumination protocol proposed by Lloyd [Science 321, 1463 (2008)] and S. Tan etal. [Phys. Rev. Lett. 101, 253601 (2008)], achieved in a simple feasible experimental scheme based on photon-number correlations. A main achievement of our result is the demonstration of a strong robustness of the quantum protocol to noise and losses that challenges some widespread wisdom about quantum technologies.