This study focuses on the discovery of a single-component molecular resist for extreme ultraviolet (EUV) lithography by employing the ionizing radiation-induced decomposition of carbon-fluorine chemical bonds. The target material, DHP-L6, was synthesized by bonding perfluoroalkyl ether moieties to amorphous dendritic hexaphenol (DHP) with a high glass transition temperature. Upon exposure to EUV and electron beam irradiation, DHP-L6 films exhibited a decreasing solubility in fluorous developer media, resulting in negative-tone images. The underlying chemical mechanisms were elucidated by Fourier transform-infrared spectroscopy (FT-IR), X-ray photoelectron spectroscopy, and nanoindentation experiments. These analyses highlighted the possible electron-induced decomposition of C-F bonds in DHP-L6, leading to molecular network formation via recombination of the resulting C-centered radicals. Subsequent high-resolution lithographic patterning under EUV irradiation showed that DHP-L6 could create stencil patterns with a line width of 26 nm at an exposure dose of 110 mJ cm-2. These results confirm that single-component small molecular compounds with fluoroalkyl moieties can be employed as patterning materials under ionizing radiation. Nonetheless, additional research is required to reduce the relatively high exposure energy for high-resolution patterning and to enhance the line-edge roughness of the produced stencil.
Read full abstract