Abstract
The performance of water- and solvent-cast, two-component photoresist films containing poly(2-isopropenyl-2-oxazoline) or poly(2-isopropenyl-2-oxazoline-co-styrene) with a photoacid generator has been investigated. These materials afford negative-tone images after deep-UV exposure and development in a suitable medium (water or toluene). Resist solutions prepared from polymers containing at least 80 mol % 2-isopropenyl-2-oxazoline may be cast from and developed in pure water. Features of higher quality can be obtained when the resist is cast from 2-methoxyethanol, probably because side reactions such as partial hydrolysis of the pendant oxazoline rings in aqueous environments are avoided. It was possible to resolve micrometer scale patterns using ca. 200 mJ/cm2 of irradiation at 254 nm, followed by heating 2 min at 130°C and development in water alone. Image quality and etch resistance were improved using copolymers containing up to 20 mol % of styrene repeat units. © 1999 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 37: 1225–1236, 1999
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Polymer Science Part A: Polymer Chemistry
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.