The mechanical properties of the water-swellable rubber prepared by blending polychloroprene with precipitated silica, crosslinked sodium polyacrylate, polyethylene oxide, and vulcanizing agents—such as stress at break, strain at break, modulus, energy at break, and hardness—were studied before and after swelling with water. The results showed that the addition of the reinforcing filler (precipitated silica) increased the mechanical properties, while adding crosslinked sodium polyacrylate decreased the mechanical properties, although it could improve water-absorbent properties of the water-swellable rubber. If some polyethylene oxide was included in the rubber formulation, the water-absorbent properties and the mechanical properties of the rubber both increased; but, with the increase of more polyethylene oxide, the mechanical properties decreased. Wide-angle X-ray diffracting analysis was conducted to study the crystalline behavior of the rubber, which showed that the crystallinity of the vulcanized polychloroprene increased first and then decreased with an increase in the amount of polyethylene oxide. The crosslink density of the rubber was calculated by the Flory–Rehner equation. The mechanical strength of the rubber significantly decreased after swelling with water, compared with that before swelling with water. The morphology of blends was shown by scanning electron microscopy graphs. © 1999 John Wiley & Sons, Inc. J Appl Polym Sci 72: 577–584, 1999