Measuring the neutron spectrum in the reactor core is quite difficult to do. The commonly used technique is using a multi-foil activation-based neutron spectrometer. This technique provides precise positional measurement but low accuracy and is difficult and expensive to manufacture. A technique for measuring the neutron spectrum in the reactor core has been developed using a single moderator-based neutron spectrometer. This technique is simple, easy to make, and inexpensive. The measurement time is relatively fast, and the results are quite accurate. This technique uses a single cylindrical moderator and places seven passive Au detectors with varying depths. The response of each detector is calculated using the Monte Carlo program MCNPX. The neutron spectrum measurement in the reactor core was carried out by placing the spectrometer above the core for a few minutes. The foil activity was measured using a gamma counter, and the neutron spectrum was calculated using the UMG unfolding program. After measuring the neutron spectrum with a single moderator-based neutron spectrometer in the Triga Mark II reactor core, Kartini, compared with the simulation results, the comparison results show values that are close to the same, where the difference is around 2.2%.