A Digital Controller for Reactivity Monitoring and Power Control

Abstract

This paper introduces a controller unit for reactivity monitoring and automatic power control that was designed and constructed for the 500 kW Dalat Nuclear Research Reactor (DNRR). For power control and reactivity calculations, frequency signals from neutron measurement channels of starting and working ranges of the reactor are used. Two abovementioned independent functions were combined in an Artix-7 FPGA board for determining reactivity values by solving the point reactor kinetics equations with six delayed neutron groups and for stabilizing the reactor power at preset levels by determining the unbalance voltage signal to control the automatic control rod. With real-time calculations, the newly developed controller can monitor the reactor reactivity and control the reactor power online. The developed controller unit’s reactivity measuring and power stabilizing capabilities were assessed using the DNRR in normal operation and assumed emergency conditions and compared with those of the preexisting imported BNO-102R1 module of the DNRR control and protection system, known as ASUZ-14R. The results of the experiments show that the produced FPGA-based unit and the BNO-102R1 unit have the same technical characteristics and features, with the disparities being less than 5% and 1%, respectively, in reactivity measurement and power stabilization. The experimental data of reactivity measurements by the FPGA-based unit and the calculation results were also compared and found that the relative deviations between those are also less than 10%. The developed controller unit is capable of carrying out a variety of training and operational experiments on the DNRR.