This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper SPE 208988, “Novel Application of Abrasive Jet Perforating To Restore Productivity of a High-Potential Inactive Horizontal Oil Producer,” by Sadaf S. Chishti, SPE, Steven H. Craig, SPE, Baker Hughes, and Edward J. Wheatley, SPE, ADNOC, et al. The paper has not been peer reviewed. The complete paper illustrates a novel methodology that enabled the safe application of coiled tubing (CT) abrasive perforation to increase production in a sour horizontal extended-reach (ER) oil producer. The well was underperforming at 10% of the anticipated production rate because of a damaged lower completion. To avert a costly workover, abrasive perforation with CT was selected as a safe alternative to conventional explosives-based perforating conveyed on electric line. Introduction An offshore horizontal ER producer well was drilled with a total depth (TD) in excess of 24,000-ft measured depth (MD). During the completion phase, a 4.5-in. liner with 16 inflow control devices (ICDs) and eight swellable packers was run with the ICDs in the closed position. Swellable packers were placed after every two ICDs. To open these ICDs, an internal pressure of 2,500 psi was required, achieved by dropping a ball that would seat in the float collar. Multiple attempts were made to pressure up and open the ICDs without success. The decision was made to run the upper completion with a plan to activate the ICDs using rigless CT intervention. After a drift CT run, multiple attempts were made to run a through-tubing inflatable packer bottomhole assembly (BHA) on CT to isolate and pressure up the well. All attempts failed to reach target depth, with repeated holdup at approximately 20,273-ft MD. Production-logging passes performed in injection mode determined that the well interval between 20,262 and 20,300 ft was taking more than 80% of the injected fluid. In a subsequent CT logging run, a caliper log identified that the liner section in this interval was parted and identified an openhole section with washouts in excess of 7-in. inner diameter. The results from the log are shown in Fig. 1, with the enlarged section representing the parted liner/openhole interval. Because the ICDs remained closed along with a damaged liner section, the options of recovery leaned heavily toward a rig-based workover for sidetrack and recompletion. Considering time and cost constraints, studies commenced to identify an efficient alternative to establish flow contribution from the inactive compartments by adding perforations. CT was chosen as the conveyance method based on previous success in reaching TD, and three options were evaluated. Based on the lowest risk level and availability of resources, the safest and most-viable option was abrasive perforation with CT. This technique uses a sand jet perforator, a downhole tool that uses high-pressure abrasive-laden fluids to penetrate the casing, liner, and cement and extend a cavity into the reservoir.