A general gain-enhancement technique for operational amplifiers using a replica amplifier is described. Unlike conventional techniques such as cascoding, which increases the gain by increasing the output resistance, the replica-amp technique increase the gain by matching the main and the replica amps. Among the advantages of the replica-amp technique are low supply, high swing, and effectiveness with resistive loads. This technique has been demonstrated in a 1.2- mu m CMOS two-stage op amp. Operating from +or-1-V supplies, the op amp has an effective open-loop dc gain of greater than 10 000, while maintaining a high swing of 100 mV from either supply rails. The gain-enhancement circuit is shown to have only a small effect on the settling time experimentally, analytically, and in SPICE simulation.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">></ETX>