Abstract
A general gain-enhancement technique for operational amplifiers using a replica amplifier is described. Unlike conventional techniques such as cascoding, which increases the gain by increasing the output resistance, the replica-amp technique increase the gain by matching the main and the replica amps. Among the advantages of the replica-amp technique are low supply, high swing, and effectiveness with resistive loads. This technique has been demonstrated in a 1.2- mu m CMOS two-stage op amp. Operating from +or-1-V supplies, the op amp has an effective open-loop dc gain of greater than 10 000, while maintaining a high swing of 100 mV from either supply rails. The gain-enhancement circuit is shown to have only a small effect on the settling time experimentally, analytically, and in SPICE simulation.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">></ETX>
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
