BackgroundPatients presenting with partially impacted lower third molars (M3) have a higher likelihood of experiencing angle fractures while simultaneously decreasing the risk of condylar fractures. However, the specific biomechanical mechanism responsible for this occurrence remains unclear. Moreover, there is an ongoing debate regarding whether the removal of M3s might actually increase the risk of condylar fractures. This study aimed to evaluate how the presence of M3s influences mandibular fractures resulting from blows to the symphysis and lateral mandibular body, and to determine the indication for extracting M3s in such cases.MethodsModels of the mandible with a partially M3-impacted model (M3I), M3-extracted model (M3E), and M3-absent model (M3A) were generated using a computer. A traumatic blown force of 2000 N was applied to the symphysis and the right body of the mandible. Von Mises and principal stresses were analyzed, and failure indexes were determined. Two cases of mandibular linear fractures were chosen for model verification and interpretation.ResultsWhen force was applied to the symphysis, the condylar region exhibited the highest stress levels, while stress in the mandibular angle region was much less regardless of the M3 state. On applying the force to the right mandibular body, stress in the condylar region decreased while stress in the mandibular body increased, especially in the blown regions. Impacted tooth or cavity formation post-M3 extraction led to uneven stress distribution on the blown side of the mandible, increasing the risk of mandibular angle fractures. In cases where M3 was absent or the extraction socket had healed, stress from lateral traumatic blown force was evenly distributed along both the inner and outer oblique lines of the mandible, thereby reducing the risk of mandibular fractures.ConclusionsThe reduced risk of condylar fractures in patients with partially impacted lower M3s and mandibular angle fractures is mainly due to lateral blows on the mandible, which generate less stress in the condylar region than blows on the mandibular symphysis, rather than being caused by the M3 itself. Extraction of the lower M3 can decrease the risk of mandibular fractures, with a minor influence on condylar fractures.
Read full abstract