The microstructure and wear properties of a new developed Al2024\\SiFe and Al2024\\SiFe\\Al 2O 3 metal matrix composites (MMCs) produced by powder metallurgy have been investigated. Some heat treatments were applied to the extruded Al2024\\SiFe and Al2024\\SiFe\\Al 2O 3 samples to obtain the crystallization of iron compound in the Chinese script form and to avoid the needlelike and starlike morphology. The temperature 515°C was obtained as the best temperature for the heat treatment, because it results in minimum liquid phase formation and yields good dissolution of iron intermetallics in all the alloys considered. Dry sliding wear tests were applied using a pin on-ring dry wear test. Pin specimens of 8 mm diameter and 12 mm in length, were machined from Al2024, Al2024\\SiFe and Al2024\\SiFe\\Al 2O 3 samples, which were rubbed against rotating steel ring (SAE 1045) at a sliding speed of 0.15–2.0 ms −1 over the load range from 40–350 N. After dry sliding wear the debris and worn surface were studied by scanning electron microscopy (SEM), energy-dispersive spectrometry (EDS) and X-ray diffractometry (XRD). According to EDS and XRD results, the debris for mild wear mainly consisted of ferric oxide (Fe 2O 3), while the debris for severe wear was composed of Al 2O 3, Al, α-Fe phases. Moreover, the addition of SiFe eutectic alloy and Al 2O 3 particulates increased the transition load from mild to severe wear of Al2024 alloy by more than three times and decreased the coefficient of friction. The mechanism of wear does not change by the addition of SiFe eutectic alloy powders and Al 2O 3 particulates reinforcement. In addition, three wear regimes were seen, which are namely oxidation-induced delamination, high strain-induced delamination, and sub-surface delamination (microgroving). Nevertheless, it was seen that the transition load is completely different for matrix and particulates, but the transition from mild to severe wear forms at the same wear rate, about 4.2×10 −3 mm 3 m − 1 in both the matrix and the composite.
Read full abstract
Sep 23, 2010
Naoko Oono + 4
