Introduction Plastic photoreforming using photocatalysts is a solar-powered technology that facilitates the generation of hydrogen (H2) from water while simultaneously breaking down plastic waste into valuable organic products. While the focus in the past few decades has predominantly centered on enhancing the H2 production efficiency, recent attention has shifted towards selective plastic oxidation reactions (U. Nwosu, et al. Renew. Sust. Energ. Rev. , 2021, 148, 111266). However, the investigation of effective cocatalysts for selective oxidation of plastic compounds has not been well studied.The photoelectrochemical (PEC) system offers a promising approach by segregating the anodic and cathodic processes, thereby enabling a more concentrated focus on the oxidation reaction in the design of reactions. In this study, we evaluate the BiVO4 photoanode modified with various cocatalysts, for example, cobalt phosphate (Co-Pi) for the oxidation of ethylene glycol (EG), a crucial component in the formation of polyethylene terephthalate (PET). Additionally, we introduce acetonitrile (MeCN) into the reactant mixture to suppress the oxygen evolution reaction (OER), which otherwise competes with the ethylene glycol oxidation reaction (EGOR), creating a more conducive reaction environment for enhanced efficiency. Materials and Methods The BiVO4 photoanode on fluorine doped tin oxide (FTO) glass was fabricated as previously reported (V. Andrei, et al. Adv. Energy Mater , 2018, 8, 1801403). Briefly,BiOI precursor was electrochemically deposited on the FTO glass and then drop-casted a vanadyl acetylacetonate [VO(acac)2] solution onto the surface and heated at 723 K for 60 min. The deposition of the Co-Pi cocatalyst onto BiVO4 was achieved by photoassisted electrodeposition method. The obtained photoanodes were characterized by X-ray diffraction (XRD) and scanning electron microscope (SEM). PEC measurements were carried out using a three-electrode configuration under simulated solar irradiation (100 mW cm− 2, AM 1.5G). The experiments were performed in various solutions containing 1 M EG: 0.5 M Na2SO4 in H2O, 0.1 M NaClO4 in MeCN, and the mixed solution of MeCN and H2O. Product analysis was performed using proton nuclear magnetic resonance (1H NMR). Results and discussion According to the XRD and SEM results, the formation of nanoporous BiVO4 film on FTO glass was confirmed. To assess the PEC performance for EGOR using BiVO4 electrode, we carried out the experiments under conditions with and without the EG substrate (Figure (a)). With the addition of EG, a notable shift of the onset potential from 0.6 VRHE to 0.5 VRHE was observed. In addition, the photocurrent density at 1.2 VRHE increased from 0.67 mA/cm2 to 0.92 mA/cm2. This result indicates that EGOR is more favorable on the BiVO4 surface compared to OER. The Co-Pi cocatalyst deposition on the BiVO4 notably increased the current under both conditions, with and without the EG substrate. Although Co-Pi is commonly recognized for its catalytic role in OER, our experiment surprisingly revealed its positive impact on EG performance as well. The Co-Pi/BiVO4 photoanode exhibited a negative shift of the onset potential to 0.3 VRHE and an enhancement of photocurrent density to 2.04 mA/cm2 at 1.2 VRHE for EGOR compared to bare BiVO4. Additionally, the Co-Pi/BiVO4 photoanode showed 16.9% and 2.7% faradaic efficiencies (FE) for formate and glyoxal production, respectively, while bare BiVO4 exhibited 10.6% FE for formate and no glyoxal production.Under aqueous conditions, the FE for EGOR is currently low due to the competition between OER and EGOR. To overcome this challenge and enhance the EGOR efficiency, we introduced MeCN into the aqueous solution because MeCN has higher (more positive) anodic oxidation potential than the aqueous medium (L. M. Reid, et al. Sustainable Energy Fuels , 2018, 2, 1905-1927). In the MeCN-water mixed solution (MeCN:water = 9:1), OER was effectively suppressed to 0.33 mA/cm2, while EGOR was significantly enhanced to 2.50 mA/cm2 at 1.2 VRHE potential (Figure (b)). This MeCN-water mixed solvent created a more favorable environment for EGOR on bare BiVO4, resulting in a notable increase in FE for formate to 19.8% and FE for glyoxal to 13.2%, which represents a 1.87 and 4.89 times improvement, respectively, compared to the pure aqueous condition. Conclusions The deposition of Co-Pi cocatalyst on the BiVO4 film improved the photocurrent density and FE for formate production. Moreover, the introduction of MeCN in the solvent created a more favolable reaction condition for EGOR, suppressing OER and increasing the EGOR activity. Figure 1
Search from 250 M+ research papersSearch from 250 M+ research papers
Aug 13, 2024
Ahmed Tawfik + 2
Open Access