AbstractAs thermosetting resins and composites made from them begin to be used in critical applications, it becomes necessary to monitor and analyze the cure of the resin within the confines of the processing equipment. Such measurements have been carried out using a dielectric technique called dielectrometry or dielectric analysis. Conventional dielectrometry has certain limitations associated with the use of parallel plate geometry for electrodes. For in situ measurement of cure, intrusiveness of electrodes is a problem which may require placement of electrodes in non‐strategic areas. Since electrode spacing changes during cure, it is difficult to deduce permittivity and loss factor from the data. At lower frequencies the capacitive currents are small and signal‐to‐noise ratios are small, therefore, measurement at low frequencies (>100 Hz) typically require large electrode sizes. One approach to overcome the problems described above is the development of microdielectrometry. A solid state integrated circuit chip, 2 by 4 mm in size, is used as the sensor. The miniature sensor can measure the properties of a dielectric on its surface, therefore it need not intrude into the composite part. Transistors which are built into the integrated circuit are used to amplify the signal to make low frequency (>1 Hz) measurements feasible. The electrode geometry does not change, therefore loss factor and permittivity data can be deduced in real‐time. During cure of the resin or composite material, permittivity and loss factor are measured continuously at a series of preselected frequencies. Real‐time‐data is plotted on a strip chart and is also stored in a cassette for later analysis. Temperature of the curing material is measured either by a diode on the sensor or by externally placed thermocouples. Results on an aromatic amine cured epoxy resin and a dicyandiamide cured epoxy resin prepreg are presented in this report. The data obtained by microdielectrometry is compared and correlated to results obtained using differential scanning calorimetry, infrared analysis, and dynamic mechanical analysis. Results show that microdielectrometry can be used to follow the cure of epoxy resins and absolute measurements of permittivity and loss factor can be made to provide information on the mechanisms that produce the observed changes. Data at 1 Hz can be obtained but for certain lossy systems at typical cure temperatures, the data is often out of range of the instrument, thus restricting use to 10 Hz and higher frequencies. At very high loss factors (>100) a “blocking” phenomenon is observed due to charge pile up at electrode surfaces which results in erroneously high permittivity values.