Compact Cold Atom Clock Research Articles

An additive-manufactured microwave cavity for a compact cold-atom clock

We present an additive-manufactured microwave cavity for a Ramsey-type, double resonance, compact cold-atom clock. Atoms can be laser cooled inside the cavity using a grating magneto-optic trap with the cavity providing an excellent TE011-like mode while maintaining sufficient optical access for atomic detection. The cavity features a low Q-factor of 360 which conveniently reduces the cavity pulling of the future clock. Despite the potential porosity of the additive-manufacturing process, we demonstrate that the cavity is well-suited for vacuum. A preliminary clock setup using cold atoms allows for measuring the Zeeman spectrum and Rabi oscillations in the cavity which enables us to infer excellent field uniformity and homogeneity, respectively, across the volume accessed by the cold atoms. Ramsey spectroscopy is demonstrated, indicating that the cavity is suitable for clock applications. Finally, we discuss the limitations of the future clock.

A compact cold-atom clock based on a loop-gap cavity

We introduce a compact atomic clock based on laser-cooled atoms trapped inside a loop-gap microwave cavity. The cavity occupies a volume eight times smaller than conventional cylindrical cavities while maintaining a high quality factor in the presence of the ten apertures required for optical manipulation of cold atoms. The measured linewidth of the Ramsey spectrum, which is limited by the free fall distance of the atomic cloud in the cavity, was 19.6 Hz. The corresponding frequency instability was σy(τ) = 2.5 × 10−12 τ−1/2, which could be further improved by reducing the local oscillator noise. This work paves a way toward high-performance portable atomic clocks.

An effective pumping method for increasing atomic utilization in a compact cold atom clock* *Project supported by the National Natural Science Foundation of China (Grant Nos. 61727821, 61875215, and 11904408).

We propose a simple pumping method to increase the effective population of cold atoms in the clock state and investigate the factors which affect the pumping efficiency in cold atom systems. We report the theory and demonstrate the corresponding experiment in an 87Rb integrating sphere cold atom clock. The experimental results show that the population of cold atoms in the Zeeman sublevel |F = 2, mF = 0〉 is approximately 1.62 times that of the result using optical pumping alone. This method can also be applied to increase the effective population in any one of the target Zeeman sublevels in other cold atom systems.

Distortion of Rabi oscillations in a compact cold-atom clock

We report on experimental measurements and theoretical calculations of Rabi oscillation distortion during rubidium clock transition in a compact cold-atom clock. The distortion of the Rabi oscillations of the clock transition caused by the magnetically sensitive transitions between magnetic sublevels is related to the duration and amplitude of the microwave pulse, the density distribution of cold atoms, and the biased magnetic field inside the microwave cavity. The theoretical calculations agreed well with the experimental results. The Rabi oscillation measurements are beneficial for determining the optimal parameters of a cold-atom clock and identifying the uniformity of the microwave field inside the cavity. This measurement can be extended to the atomic fountain clock and the vapor-cell atomic clock.

Compact Cold-Atom Clock for Onboard Timebase: Tests in Reduced Gravity

We present a compact atomic clock using cold rubidium atoms based on an isotropic light cooling, a Ramsey microwave interrogation and an absorption detection. Its technology readiness level is suitable to industrial transfer. We use a fibre optical bench, based on a frequency-doubled telecom laser. The isotropic light cooling technique allows us to cool down the atoms in 100 ms and works with a cycle time around 200 ms. We carried out measurements in simulated microgravity and obtained the narrowest fringes ever recorded in microgravity.

Scheme for a compact cold-atom clock based on diffuse laser cooling in a cylindrical cavity

We present a scheme for a compact rubidium cold-atom clock which performs diffuse light cooling, microwave interrogation, and detection of the clock signal in a cylindrical microwave cavity. The diffuse light is produced by laser light reflection at the inner surface of the microwave cavity. The pattern of the injected laser beams is specially designed to accumulate the majority of the cold atoms in the center of the microwave cavity. Microwave interrogation of the cold atoms in the cavity leads to Ramsey fringes, which have a linewidth of $24.5$ Hz with a contrast of $95.6%$ when the free evolution time is 20 ms. Recently, a frequency stability of $7.3\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}13}\phantom{\rule{0.28em}{0ex}}{\ensuremath{\tau}}^{\ensuremath{-}1/2}$ has been achieved. The scheme of this physical package can largely reduce the cold-atom clock complexity and increase clock performance.

Cooling of rubidium atoms in pulsed diffuse laser light

This paper reports an experiment on laser cooling of 87Rb atoms in pulsed diffuse light, which is the key step towards a compact cold atom clock. It deduces an empirical formula to simulate the pulse cooling process based on the loading of cold atoms in cooling time and the loss in the dead time, which is in agreement with the experimental data. The formula gives a reference to select the parameters for the cold atom clock.

HORACE: A compact cold atom clock for Galileo

HORACE (HOrloge à Refroidissement d’Atomes en Cellule = clock based on atoms cooled from vapour cell) is a compact cold caesium atom clock developed in SYRTE at Paris Observatory. This clock can operate both on ground and in microgravity environment. Design of HORACE is based on isotropic light cooling, allowing performing the whole clock sequence (cooling, atomic preparation, Ramsey interrogation and detection) at the same place. Compared to more conventional cold atom clocks such as atomic fountains, the use of isotropic light cooling simplifies both the optical part of the setup and the detection sequence, and leads to a drastic size reduction of the physics package. Very good short-term performances have been demonstrated at SYRTE since relative frequency instability of 2.2 × 10 −13 τ −1/2 has been obtained. Optimization of the long term stability is still under progress and current results show relative frequency instability around 3 × 10 −15 in 10 4 s of integration. With these performances, HORACE appears as a good candidate both for Galileo’s ground segment clock and for onboard Galileo clock.

High-stability compact atomic clock based on isotropic laser cooling

We present a compact cold-atom clock configuration where isotropic laser cooling, microwave interrogation, and clock signal detection are successively performed inside a spherical microwave cavity. For ground operation, a typical Ramsey fringe width of 20 Hz has been demonstrated, limited by the atom cloud's free fall in the cavity. The isotropic cooling light's disordered properties provide a large and stable number of cold atoms, leading to a high signal-to-noise ratio limited by atomic shot noise. A relative frequency stability of $2.2\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}13}{\ensuremath{\tau}}^{\ensuremath{-}1/2}$ has been achieved, averaged down to $4\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}15}$ after $5\ifmmode\times\else\texttimes\fi{}{10}^{3}$ s of integration. Development of such a high-performance compact clock is of major relevance for on-board applications, such as satellite-positioning systems. As a cesium clock, it opens the door to a new generation of compact primary standards and timekeeping devices.

Laser cooling of rubidium atoms from background vapor in diffuse light

In this paper we describe an experiment on laser cooling of $^{87}\mathrm{Rb}$ atoms directly from a vapor background in diffuse light. Diffuse light is produced in a ceramic integrating sphere by multiple scattering of two laser beams injected through multimode fibers. A probe beam, whose propagation direction is either horizontal or vertical, is used to detect cold atoms. We measured the absorption spectra of the cold atoms by scanning the frequency of the probe beam, and observed both the absorption signal and the time of flight signal after we switched off the cooling light, from which we estimated the temperature and the number of cold atoms. This method is clearly attractive for building a compact cold atom clock.