Banana Stem Fiber Research Articles

The Used of Pineapple Leaf Fiber, Banana Stem and Kenaf for Production of Paper

The paper explores the use of pineapple leaf fiber (PALF), banana stem fiber and kenaf fiber to produce paper has been done in order to find the alternative source and the method to recyle used newspaper. The decreasing of already material which is cause by the unstable ecosystem and taking long time to harvest. The alternative source can help to increase production of paper and reduce the cost of production. The experiments using PALF, banana stem fiber and kenaf fiber as raw material in paper production have been conducted to assess the advantages in terms of mechanical properties, especially tensile strength, tearing strength, thickness, and grammage of paper. The result obtained from the tests will be compared among the three types of material. Through the observation of the experiment, it was found that the data obtained with different properties of paper produced from the different material.

Effect of Microcrystalline Cellulose from Banana Stem Fiber on Mechanical Properties and Crystallinity of PLA Composite Films

This work focused on the preparation of the biocomposite films of polylactic acid (PLA) reinforced with microcrystalline cellulose (MCC) prepared from agricultural waste, banana stem fiber, and commercial microcrystalline cellulose, Avicel PH 101. Banana stem microcrystalline cellulose (BS MCC) was prepared by three steps, delignification, bleaching, and acid hydrolysis. PLA and two types of MCC were processed using twin screw extruder and fabricated into film by a compression molding. The mechanical and crystalline behaviors of the biocomopsite films were investigated as a function of type and amount of MCC. The tensile strength and Young’s modulus of PLA composites were increased when concentration of MCC increased. Particularly, banana stem (BS MCC) can enhance tensile strength and Young’s modulus of PLA composites than the commercial MCC (Avicel PH 101) because BS MCC had better dispersion in PLA matrix than Avicel PH 101. This result was confirmed by SEM image of fractured surface of PLA composites. In addition, XRD patterns of BS MCC/PLA composites exhibited higher crystalline peak than that of Avicel PH 101/PLA composites

Chemical composition, anatomy, lignin distribution, and cell wall structure of Malaysian plant waste fibers

The chemical composition, anatomical characteristics, lignin distribution, and cell wall structure of oil palm frond (OPF), coconut (COIR), pine-apple leaf (PALF), and banana stem (BS) fibers were analyzed. The chemical composition of fiber was analyzed according to TAPPI Methods. Light microscopy (LM) and transmission electron microscopy (TEM) were used to observe and determine the cell wall structure and lignin distribution of various agro-waste fibers. The results revealed differences in anatomical characteristics, lignin distributions, and cell wall structure of the different types of fibers investigated. Nevertheless, transmission electron microscopy (TEM) micrographs have confirmed that the well wall structure, in each case, could be described in terms of a classical cell wall structure, consisting of primary (P) and secondary (S 1 , S 2 , and S 3 ) layers.