This study explored Mason pine-derived hydrochar (MPHC) as an effective adsorbent and persulfate (PS) activator for degrading bisphenol A (BPA). Increasing MPHC dosage from 0.25 to 2.0 g L−1 raised BPA removal from 42% to 87%. Similarly, at the same MPHC dosage range and fixed PS concentration (8 mM), BPA removal by MPHC/PS increased from 66% to 91%. Additionally, at a fixed MPHC dosage (1.0 g L−1), higher PS concentrations (2–32 mM) resulted in an overall BPA removal increase from 78% to 99%. The optimal pH for BPA removal by MPHC was at pH 3, while for MPHC/PS was at pH 9. BPA degradation by MPHC was optimal at pH 3, whereas MPHC/PS was at pH 3 and pH 9. Additionally, pH 7 favored BPA adsorption for both MPHC and MPHC/PS. The study also considered the influence of coexisting anions and humic acid (HA). PO43− and NO3− influence adsorption on MPHC, but these anions' effect on MPHC/PS is limited. Furthermore, the existence of HA had minimal influence on BPA removal by MPHC/PS. The contributions of different reactive species by MPHC for BPA degradation are as follows: electron-hole (h+) 2%, singlet oxygen (1O2) 7%, superoxide radicals (O2•–) 13%, electron (e–) 2%, hydroxyl radical (•OH) 3%, whereas the remaining 48% removal was the contribution of adsorption. For MPHC/PS, adsorption accounted for 39 %, more reactive species were involved in degradation, and the donations are (h+) 3%, sulfate radicals (SO4•–) 3%, (1O2) 19%, (O2•–) 15%, (e–) 2%, and (•OH) 2%. Additionally, the performance of MPHC remains stable after three operational cycles. The preparation cost of MPHC is 3.01 € kg−1. These results highlight the potential of MPHC as an environmentally friendly material for activating PS and removing organic pollutants, suggesting its promising application in future environmental remediation efforts.