BackgroundThe aim of this study is to find a correlation between linear measurements and the graft length required for different anterior cruciate ligament (ACL) revision techniques, to extract formulas to predict required graft length during the preoperative planning.MethodsAt time 0 and 30 days later, two observers measured eight linear distances on standard 2D knee magnetic resonance imaging (MRI), and nine curved distances on 3D MRI sequences, corresponding to different techniques for ACL revision, anatomic anterolateral ligament (ALL) reconstruction, and lateral extrarticular tenodesis (LET). Intra- and interobserver reliability was tested for 2D and 3D measurements. The correlation between 2D and 3D measurements was tested. The 2D measurements with highest repeatability and reproducibility, and with strongest correlation with 3D measurements were used to extract formulas to calculate the graft length from 2D values.ResultsFifty MRIs acquired with both 2D and 3D sequences were used. The intra- and interobserver reliability of linear 2D measurement was high, with the transepicondylar distance (TD) showing the highest reproducibility and repeatability. The intra- and interobserver reliability of 3D measurements was lower than 2D, but acceptable for all measurements except for ALL reconstruction. The TD showed the strongest correlation with 3D measurements. The formulas extracted to calculate the graft length from the TD proved to be accurate.ConclusionAccurate formulas were created to calculate the graft length needed for different ACL revision techniques and ALL reconstruction/LET techniques from TD. These formulas can be used during preoperative planning of ACL revision cases.