Wind tunnel experimental study of aerodynamic characteristics of co-flow jet wing with built-in air source

Abstract

To further investigate the aerodynamic characteristics and control mechanisms of co-flow jet wings, this study presents the design of a co-flow jet wing (CFJ-CLARKY18) with an embedded micro centrifugal compressor. The CFJ-CLARKY18 wing, based on the CLARKY18 airfoil, incorporates a miniature centrifugal compressor positioned horizontally within the wing's cavity, with its rotor axis perpendicular to the wing chord line, thus alleviating geometric constraints and the compressor's exhaust swirl. The integration of the co-flow jet device with the wing is achieved through a split-flow channel design to ensure uniform co-flow jet injection, followed by verification of jet uniformity and calibration of six jet momentum coefficients. Subsequently, static and dynamic control experiments of the co-flow jet wing are conducted in an open-return wind tunnel, utilizing force measurement systems and high-speed particle image velocimetry tools to investigate its aerodynamic characteristics and control mechanisms. Static stall tests indicate that, compared to the original wing, the CFJ-CLARKY18 wing exhibits a significant increase in lift and a noticeable delay in stall angle. At low angles of attack, an increase in co-flow jet momentum leads to a reduction in drag coefficient, with the possibility of achieving negative drag (thrust) even at high co-flow jet momentum coefficients. The results of dynamic stall tests with force measurements indicate that, while keeping the reduced frequency constant, an increase in co-flow jet momentum coefficient results in higher maximum lift and average lift coefficients, accompanied by a significant reduction in average drag coefficient and the hysteresis loop area of the lift coefficient. Despite the increased reduced frequency exacerbating the wing's stall effect, the stall effect weakens significantly once the co-flow jet momentum coefficient is increased.