Wavelength-band-tuning photodiodes by using various metallic nanoparticles

Abstract

Wavelength-band tuning was easily achieved in this work by depositing various metallic nanoparticles (NPs) on silicon p-n junction photodiodes (PDs). The normalization spectrum of the PDs deposited with gold (Au) NPs reveals a high-wavelength pass characteristic; the PDs with silver (Ag) NPs coating behave as a low-wavelength pass, and the PDs with Au/Ag bimetallic NPs appear as a band-wavelength pass PD with a full width at half maximum of 450 ∼ 630 nm. The issue of wavelength-band tuning is due to the different plasmonic resonance wavelengths associated with various metallic NPs. The extinction plot shows the Au NPs have a longer resonant wavelength of about 545 nm, leading to the incident light with a wavelength near or longer than 545 nm scattered by the Au NPs, hence a high-wavelength pass PD. The PDs with Ag NPs, due to the Ag NPs, exhibit a short resonant wavelength of 430 nm, and the short-wavelength incident light is absorbed near the silicon (Si) surface, where the Ag NPs is atop it. The shorter-wavelength incident light is enhanced by the plasmonic resonance of Ag NPs, making a low-wavelength PD. The Au/Ag NPs presents a resonant wavelength of 500 nm between the Au and Ag NPs. For the incident light with a wavelength close to 500 nm, a constructive interference causes a substantial increase in the local electromagnetic field, hence leading to a band-wavelength pass PD.