Use of hyperboloid as an adjunct in functional jaw orthopedics – case report

Abstract

Anterior open bite can be defined as a malocclusion with a negative vertical discrepancy between the incisal edges of the upper and lower anterior teeth, which do not have occlusal contacts with the antagonists and sometimes extends to the canines and, less frequently, to the premolars is one of the malocclusions with the greatest aesthetic and/or functional impairment. Anterior open bite can have several etiologies: finger sucking and/or pacifier, oral breathing, onychophagia, lip interposition, atypical swallowing, tongue interposition when uttering phonemes and anterior posture of the tongue at rest. Orofacial myofunctional disorders are present in cases of anterior open bite, generally associated with etiologies and adapt to this altered morphological condition. Regarding the anterior opening amplitude, the anterior open bite is classified as: minimum up to 1 mm, moderate between 1 and 5 mm and severe +5 mm [1]. Open bite can be classified into: maxillary, mandibular and hybrid open bite [2]. Myofunctional therapy is considered a treatment method that can increase muscle strength, cause changes in functional patterns and thus prevent deviations in craniofacial development, as it promotes new posture of structures at rest and during the performance of the functions of the stomatognathic system [3]. The hyperboloid is an instrument for increasing muscle tone and when used in chewing, it is efficient in inducing growth and remodeling. The hyperboloid fills a gap in the modern diet, with the consistency of hard, raw and dry foods [4]. Exercises with a size M hyperboloid with wire were prescribed as an initial approach. After 2 months of treatment, there was an improvement in the interincisor distance. The exercise was maintained for another 5 months. He stopped attending appointments for 2 years and 2 months. Upon his return, the results of the functional examination of swallowing, chewing, protrusion and laterality were observed, and we opted for the installation of the SN3. the hyperboloid, in this case, showed its efficiency in balancing the stomatognathic system.