Abstract
In this work, the uncatalysed and catalysed combustion of two commercial carbon blacks and three diesel soot samples were analysed and related to the physico-chemical properties of these carbon materials. Model soot samples are less reactive than real soot samples, which can be attributed, mainly, to a lower proportion in heteroatoms and a higher graphitic order for the case of one of the carbon blacks. Among the diesel soot samples tested, the most relevant differences are the volatile matter/fixed carbon contents, which are directly related to the engine operating conditions (idle or loaded) and to the use of an oxidation catalyst or not in the exhaust. The soot collected after an oxidation catalyst (A-soot) is more reactive than the counterpart virgin soot obtained under the same engine operating modes but before the oxidation catalyst. The reactivity of the different soot samples follows the same trend under uncatalysed and catalysed combustion, the combustion profiles being always shifted towards lower temperatures for the catalysed reactions. The differences between the soot samples become less relevant in the presence of a catalyst. The ceria–zirconia catalysts tested are very effective not only to oxidise soot but also to combust the soluble organic fraction emitted at low temperatures. The most reactive soot (A-soot) exhibits a T 50% parameter of 450 °C when using the most active catalyst.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.