Abstract
PurposeThe serious friction and wear problem occurs on the mechanical seal’s faces during the start-up stage of the high-speed turbopump for a liquid rocket engine. This paper aims to propose a kind of thick metal alloy coatings on the surface of the seal’s rotor so as reduce the friction and wear.Design/methodology/approachWith the pin-disk (the graphite pin and the disk with the metal coating) tribology-tester, the tribological behaviors of four metal coatings are investigated. The special friction coefficients under the dry friction, boundary friction and different temperatures of water-lubricated conditions were obtained.FindingsThe test results show that the thick metal coating has a good performance of the wear resistance and friction reduction; and the friction coefficients of a Sn-Sb-Cu coating under the dry friction and water-lubricated conditions are 0.377 and 0.043, respectively, and the corresponding mass wear volumes are only 2.74 and 0.81 mg, respectively.Originality/valueThe thick metal coating scheme for the mechanical seal’s faces might lend itself to the harsh working conditions of the low-viscosity liquid rocket engine.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
