Abstract
The dependencies of PcBN Kiborit cutters wear described allows to propose the method of real relief worn flank surface area of cutter calculation when the total main and additional cutting edges length, flank wear height and average tilt angle of micron relief wear groove walls measured are determined. Based on the studies carried out, it has been established that the presence of a furrow-like profile on the back surface of the tool increases the actual contact area with the treated material by 30 % in comparison with the area of the nominal wear contour.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The Journal of Zhytomyr State Technological University. Series: Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
